全部

1·In tangential combustion system, the reheat steam temperature can be adjusted by changing burner nozzle Angle to just the flame position.

在切向燃烧系统中，通过改变燃烧器喷口的角度可以调节炉内火焰中心位置，可达到调节再热汽温的目的。

2·The frequency of vortex increases with the augment of the casting speed, and decreases with the augment of the immersion depth and nozzle angle.

漩涡的出现频率随拉速的增加而增加，随水口浸入深度的增加而减小，随水口张角的减小而增大；

3·Get a heat gun, the one used for stripping paint, Angle its nozzle toward suspected colonies, and blast away.

找把加热枪，那种来剥除油漆的，把它的喷嘴对准疑似窝点，一阵炮轰。

4·A method based on fuzzy C-mean clustering and image matching algorithms are proposed to detect atomization Angle and uniformity, applied to performance test-bed of engine nozzle.

提出了基于模糊C均值聚类和图像匹配，检测喷雾锥角和喷雾不均匀度的方法，并应用于发动机喷嘴性能检测。

5·Also, the characteristic parameters of conical liquid sheet with centrifugal nozzle, such as half-cone Angle and breakup length, were measured under different liquid pressures.

测得不同液压差下离心喷嘴锥形液膜的各项特性参数，如液膜半锥角、液膜破碎前长度等。

6·The results show that flow separation has much effect on the performance parameters, especially the efficient deficient angle of the nozzle.

研究表明，分离流动对矢量喷管的性能参数尤其是有效矢量角具有较大影响。

7·Special silex nozzle, smooth inside, Angle precise, long-term spray, without crystal.

采用独特的石英玻璃烧制成的喷嘴，内腔圆滑，角度精确，长期喷雾，无结晶。

8·The effect of inlet size, inlet Angle, dome height, primary nozzle expansion ratio and nozzle Numbers on combustion efficiency were taken into account.

考虑了进气道尺寸、进气夹角、头部距离、一次喷嘴扩张比和喷嘴数目等结构因素对补燃室掺混与燃烧性能的影响。

9·Atomization Angle and uniformity are two key parameters of fuel spray nozzle.

喷雾锥角和喷雾均匀度是燃油喷嘴的两个重要指标。

10·When the inclination angle of a side nozzle is 0, 30,45 and 60 degrees, the eddying flow of the bottom hole vortex device will cause rotation at the bottom hole, affecting on the jet from bit nozzles.

侧喷嘴倾斜角度在0度、30度、45度和60度情况下，由于井底涡旋器的旋流作用，导致井底产生旋转，对钻头喷嘴射流产生了影响，以致在45度时出现压力损失最小的情况；