全部

1·The results showed that high dielectric constant and low loss BST film can be fabricated using this method without special anneal process.

使用这种方法不需要专门的退火工艺，就可以制备晶体结构完整的高介电常数BST薄膜。

2·Long working life and small deforming can be realized by improving anneal process and quenching process.

通过改进退火工艺和淬火工艺，获得更高使用寿命和更小的变形。

3·The resistivity and flexivity of the resistance thermostat metal change while the anneal process change.

当退火工艺变化时，电阻系列热双金属的电阻率和温曲率等主要性能将产生变化。

4·And in this article, various process parameters such as electrolysis alkali wash, pickling and chemical displacement copper plating, testing equipment type and anneal process are given.

文中给出了电解碱洗、酸洗及置换镀铜时各种工艺参数及所用试验设备型号及拉拔退火工艺。

5·Investigating the tubes of 6061t1 aluminium treated by both the extrusion and anneal, the effects of forming parameters on neck-spinning process of 3d non-axisymmetric tubes are presented.

以6061t1(挤压态及退火态)铝合金为研究对象，探讨工艺参数对三维非轴对称管件缩径旋压成形的影响。

6·The mathematic model of this process is built based on a covered anneal gas boiler, and a disturbance compensation method is provided.

并以煤气罩式退火炉为例，建立了该过程的数学模型，提出了有煤气压力干扰补偿方案。

7·For erbium ion in light-emitting layer with light activated process and other chemical reaction, it is necessary to anneal the devise with high temperature in fabrication process.

为了让发光层内铒离子具有光活化及其他的化学反应的发生，在制程中热退火是必须的。

8·The resistance and stress of Cu film will be studied by different rotation speeds, anneal process and queue time (ECP to CMP).

通过对比电镀铜工艺中不同的转速对孔洞缺陷的影响，得到电镀时转速与孔洞缺陷的关系；

9·The operation results show that the fuzzy control can overcome anneal furnace combustion process above difficulties, has stronger robustness, and can obtain satisfactory control effect.

运行结果表明，模糊控制能克服退火炉燃烧过程中的以上困难，具有较强的鲁棒性，可以获得满意的控制效果。

10·Finally, anneal process is used to resume etching damage to enhance the reliability of the element.

最后采用退火处理，进一步恢复刻蚀损伤，器件可靠性得到提高。