全部

1·The essay analyzes the problem of blow-hole which is easily seen in the process of production and makes further discussion of the technology of improving lid casting.

前言：对烘缸缸盖在铸造过程中易出现的皮下气孔问题进行了分析，并对缸盖浇注系统的工艺改进作了进一步探讨。

2·She uses her mouth to blow the water to make a current, then her blow hole to break the current into a ring shape.

她会用嘴吹出一个气泡，然后用喷气孔将气泡吹成圆环。

3·The reason and prevention of four kinds defects including surface wrinkled skin (carbon built-up), chock, blow hole, deformation, was introduced in this part of the article.

本部分主要介绍表面皱皮（积碳）、呛火、气孔、尺寸超差及变形等缺陷的产生原因和防止方法。

4·In order to remove blow hole, the influence of jute fibre on permeability of coatings for LFC was investigated.

为了解决消失模铸造件气孔问题，研究了黄麻纤维对消失模铸造涂料透气性的影响。

5·The high ambient temperature and damp weather has harmful influence on the cupola melting that causes increase of blow hole defect.

梅雨季节高温潮湿天气对冲天炉熔炼带来不利影响，导致铸件气孔缺陷增加。

6·The measures to prevent nitrogen blow hole caused by high nitrogen content of resin sand are: adopting low nitrogen resin, adding iron oxide into sand or coating and keeping resin from moisture.

防止树脂砂含氮量高引起的氮气孔的方法是：选用低氮树脂、型砂或涂料中加入氧化铁粉和避免树脂受潮。

7·The main features of the fissure type nitrogen blow hole and its formation mechanism was described.

叙述灰铸铁件裂隙状氮气孔的主要特征、形成机理。

8·That hole was caused by spall blow - out.

那个洞就是被碎片打穿的。

9·If bicycle pump, then the alignment hole - by-blow look at a better effect.

如有自行车打气筒，则对准小孔逐个吹一下效果更佳。

10·Method used to reduce blow hole defects of die castings include 4 aspects:melting, pattern die. parameters of die casting process, and stripping agent.

前言： 消除压铸件气孔的方法包含4个方面： 熔炼、 模具、压铸参数和分型剂。