全部

1·The technologies of precharge and balance, subsection decoding etc are used in the design.

在设计中采用了预充电及平衡技术，分段译码等技术。

2·This row remains active for column access until a precharge command is issued to that bank.

这个行在有效后，一直有效到预充电指令到来。

3·Note that part of the row precharge time is hidden during the access of the last data element.

注意，有一部分的预充电时间隐藏在访问最后一些数据时。

4·Without false paths, the errors of evaluation delay and precharge delay are within 3.62% and 8.26% respectively.

如果不考虑伪路径的影响，求值方向和预充方向延时的最大误差分别为3.62%和8.26%。

5·This indicates the drive is in precharge, which may happen when the applied input voltage does not match the drive's rating.

这表明该驱动器在预充电，这可能发生时，施加的输入电压不匹配的驱动器的评级。

6·Experimental results indicate that dust precharge, specially bipolar and unsymmetric precharge, improves the performance of fibre-pad filters.

实验表明，粉尘预荷电技术能有效提高纤维过滤器性能，尤以双极不对称荷电方式为最佳。

7·Key techniques of on-line concentrated sampling are analyzed and relations of accumulator precharge pressure and pressure-retaining results are studied.

分析了实现在线浓缩取样的关键技术，研究了蓄能器预充压力和采样筒保压效果的关系。

8·The main techniques used to decrease active power are :(1)reduce switch capacitance. (2)Minimize level of voltage which to precharge or discharge capacitance.

减少动态功耗的主要技术：（1）降低开关电容。（2）降低充放电电压摆幅等。

9·Depending on the fluid volume and precharge pressure of the accumulator, a limited amount of hydraulic energy is then available independent of any other power source.

根据储能器的流体体积和预充气压力，可获得某限定数量的液压能量而不依赖任何其它动力源。

10·Simulation research and practical experiments showed that: during pressure-retaining process, accumulator opening pressure is a little greater than precharge pressure;

计算研究和模拟试验表明，保压过程中蓄能器的开启压力略高于蓄能器充气压力；

预充电

1·This indicates the drive is in precharge, which may happen when the applied input voltage does not match the drive's rating.

这表明该驱动器在预充电，这可能发生时，施加的输入电压不匹配的驱动器的评级。