全部

1·All EBNER batch annealing furnaces in Tangshan Iron and Steel Group Company are introduced.

介绍了唐山钢铁集团公司所用EBN ER罩式退火炉。

2·The structure and texture of continuous or batch annealing deep drawing and extra-deep drawing steel sheets were observed and analyzed.

对连续退火或罩式退火后的深冲钢板和超深冲钢板的组织以及织构进行了观测和分析。

3·The effect of batch annealing process on the microstructure and mechanical properties of SPCCSD cold rolled steel sheet was studied under laboratory conditions.

在实验室条件下，研究了罩式退火工艺对SPCC- SD冷轧板组织和性能的影响。

4·Experiment study of heat transfer mechanism and characteristics in high velocity circulation furnace has been accomplished for batch annealing furnace with high velocity burner.

针对间歇式退火炉使用高速燃烧器，进行了在高速气流循环下的炉内热交换机构与特征的试验研究。

5·All-hydrogen batch annealing furnace is the world's leading annealing equipment of Cold Rolled Coils. The system is characterized by uniform annealing coil and advanced automation.

全氢罩式退火炉是具有世界先进水平的冷轧板卷退火设备，具有钢卷退火均匀、控制系统自动化程度高等特点。

6·According to the curve of rolled coil annealing temperature, the curve of gas and air consumption, the air volume for one batch annealing furnace and discharge flue gas system are obtained.

利用钢卷退火温度曲线以及煤气和空气消耗量曲线，得到了单台罩式炉退火过程中的抽风量变化曲线，在此基础上，得到了系统抽风量。

7·The effects of baking temperature, baking time and prestrain on the bake hardenability and dent resistance of isotropic sheet steel and BH sheet steel produced by batch annealing were studied.

研究了烘烤温度、烘烤时间和预拉伸应变量对罩式炉退火工艺生产的各向同性钢的烘烤硬化性的影响，并与力学性能相当的冷轧烘烤硬化钢进行了对比。

8·Applications: the bogie hearth electric resistance furnace is a batch type furnace, it is used for normalizing, quenching, annealing and other heat treatments of large or medium metal parts.

用途：台车式电阻炉系周期作业式电炉，可供大中型金属机件和材料的正火、淬火退火等热处理和加热之用。

9·The post-batch-annealing can improve the formability of hot dip galvanized sheet, but the formability is mainly determined by up stream process.

后罩式退火也可以改善低碳铝镇静钢热镀锌板的性能，但其冲压性能主要取决于后罩式退火前的各工序。

10·After hot rolling, only through full recrystallizing by annealing process in the batch, can the stainless steel be put into use.

不锈钢经过热轧后，需经罩式炉退火工艺使材料充分再结晶后才能投入使用。