全部

1·Most precipitate dissolve into the matrix after solution treatment.

材料经固溶处理后析出物绝大多数都溶入基体。

2·The alloy has lower intensity after solution treatment, but the plastic is best.

固溶后合金的强度较低，但塑性最好；

3·The results show that there are lots of uneven ordering domain after solution treatment.

结果发现，其固溶态含有大量有序畴的不均匀固溶体；

4·Grain growth exponent increases with the increasing of solid solution treatment temperature.

晶粒生长指数随固溶温度的升高而增加。

5·Solution treatment temperature has a significant impact on the tensile strength and elongation.

固溶处理温度对抗拉强度和延伸率有较大的影响。

6·It is important to control the forging temperature and solution treatment temperature lower rather than higher.

重要的是较低的锻造温度和热处理固溶温度比较高的好得多。

7·In the case of solution treatment adequately, the variation of wall thickness almost haven't any effect on aging.

在充分固溶的情况下，壁厚不同对时效影响不大。

8·The experimental results show that, under solution treatment condition, this alloy has lower cold-crack susceptibility.

结果表明，固溶处理状态下母材氩弧焊时具有较低的冷裂纹敏感性。

9·The alloys in plastic after solution treatment good, easy Rolling and Processing of the various parts of complex shape;

该合金在固溶处理后塑性良好，易于辗压及加工成型各种形状复杂的零件；

10·The influence to corrosion resistant ability of duplex stainless steel (SAF2205) after solution treatment to weld joint.

分析了采用焊后固溶处理对SAF2205双相不锈钢耐腐蚀性能的影响。