全部

1·This paper primary coverage is truncates in the process in the plow the cutting tool best clearance Angle research.

是在犁削过程中刀具的最佳后角的研究。

2·Besides, the influence of the machining error by the nc model and the clearance Angle of the sway back are analyzed.

此外，还分析数控模型以及回摆间隙角对加工误差的影响。

3·Clearance Angle. This is the Angle between the machined surface and the underside of the tool called the flank face.

这是机加工面与被称为后侧面的刀具底面夹角。

4·An analysis of the effect of tooth path and optimum clearance Angle on tool life in the up milling and down milling processes is presented.

本文分析了铣削轨迹及合理后角对顺铣与逆铣中刀齿耐用度的影响。

5·Results indicated that the surface roughness would not be effected by saw cutting amount as long as saw side clearance Angle wasn't changed.

分析结果表明，只要锯料角不变化，则锯料量的变化对锯切表面粗糙度不起任何作用。

6·The helical surface equations of the spherical hob are set up in spherical coordinates. The formulas of the side clearance angle and numerical examples are given.

在球坐标系中，建立了球形滚刀的各个螺旋面方程，推导了侧后角公式，并给出了计算实例。

7·Through the graphics processing of micro protrusion topography of wheel, the grain protrusion height, grain protrusion volume, grain rake angle and clearance angle were modeled.

通过砂轮微观出刃形貌的图形化处理，建立磨粒出刃高度、出刃体积、磨粒切削前角和后角等特征参数模式。

8·Cutting tool clearance Angle influence plow chip curl situation as well as fin chip superficial situation, but these two conditions are decision flyaway plow chip heat control abilities.

刀具的后角影响犁削片的卷曲情况以及翅状犁削片的表面情况，而这两个条件是决定翅状犁削片的热控制能力。

9·Design a variety of radial clearance and the contact Angle, to meet different application requirements of load and deflection.

设计有多种径向游隙和接触角，满足不同的应用负荷和偏斜要求。

10·Meanwhile, it puts forward the conception of Angle adjusting mechanism from the fact that the wheel clearance could lead the changes of phase-angle between two roller.

同时，针对由齿轮间隙引起的两冲辊之间(即凸、凹模之间)相位角的变化，提出设计角度调整机构的理念。