全部

1·Asphalt mixture fatigue life, cumulative dissipated energy and initial modulus data showed a logarithmic normal distribution.

沥青混合料的疲劳寿命和累积耗散能以及初始模量数据呈对数正态分布。

2·The tensile strength and initial modulus were remarkably decreased and the breaking elongation and flexibility of grafted fiber were increased.

接枝后纤维强度和初始模量下降，断裂伸长和柔顺性提高；耐酸、耐碱能力随接枝率的增加而提高，热稳定性提高，回潮率下降。

3·The results showed that bamboo fiber has a high initial modulus, fiber mechanical properties when wet than the dry state decreased significantly.

结果表明。竹原纤维具有较高初始模量。湿态时纤维力学性能较之干态有明显下降。

4·The results showed the loss rates of stress, initial modulus and breaking work were more than 44%, 65% and 51% after hydrothermal aging test respectively;

结果表明，在热湿条件下老化结束后，材料的断裂应力、初始模量和断裂比功的损失率分别大于44%、65%和51%；

5·The bundle tensile testing (SIROLAN - TENSOR) is used to identify damages of strength, strain, rupture work, and initial modulus of tops before and after dyeing.

采用束纤维强伸性测量方法(TENSOR)，能快速准确地给出毛条染色前后的强度、伸长、断裂功的护伤。

6·The impact of temperature and duration of heat treatment on the breaking strength, elongation at break, initial modulus and work to break of the fibers was investigated.

对玉米纤维进行不同方式的热处理实验，得出了热处理温度和热处理时间对断裂强度、断裂伸长、初始模量、断裂功的影响规律。

7·The test has shown that as the degree of profile increases, the initial modulus and the breaking strength and elongation of profile yarn decreases. We have also quined the findi...

试验表明，在相同纺丝条件下，涤纶三叶异丝的断裂强伸度和初始模量随丝条异形度的提高而降低，而断裂强伸度变异系数、沸水收缩率和条干不匀率却随之增大。

8·Results show that yarns sized by sizes with films of higher breaking elongation and specific work of rupture and lower initial modulus have better abrasive resistance and weaving performance.

研究结果表明，浆膜断裂伸长率和断裂比功大的。拉伸模量小的浆料上浆的浆纱耐磨性较好，织造性能也较比良。

9·However, the interface strength decreases after size scaling while the initial shear modulus increases, which cannot be ignored.

而粒径缩尺后的接触面强度会降低，同时初始剪切模量则有所增长，其影响不能忽略。

10·METHODS: Three-dimensional finite element method was used to analyze the initial stress around screw implant of different elastic modulus and different diameter.

方法：用三维有限元的方法对不同弹性模量和不同直径种植体植入后骨界面的初始应力进行分析。