全部

1·The output of the CLK pin will be set to the crystal frequency.

该clk引脚输出将被设置为晶振频率。

2·My question is, how do I know what the input CLK frequency should be?

我的问题是，我怎么知道输入时钟频率应该是多少？

3·Those who roll out this kind of analyzer not merely CLK company one.

推出这种分析仪的不只clk公司一家。

4·I've read the datasheet but can't find any reference to specifying an input CLK frequency.

我读过的数据表，但找不到任何参考指定一个输入时钟频率。

5·Data is read serially by the Driver IC on the input CLK rising edge once the STB input line goes low.

数据读取连续的驱动ic的输入时钟的上升沿一旦机顶盒输入线变低。

6·This would place the A5 between the BMW 3-series and 6-series, and aim it squarely at the Mercedes-Benz CLK.

这将A5置于宝马3系列和6系列，并把矛头直接指向梅赛德斯奔驰clk。

7·CLK design gives a kind won't the database of block, this means processor to will never hold unwanted position.

CLK设计出一种不会梗阻的数据库，这就象征着措置器决不会保持空闲状况。

8·The fiducial clk and reset source of each part is same , and the information transmitted form part to part is on line.

在设计中整个系统采用了一个基准时钟源和同步源，并且各部分间的信号传输采用了有线的方式。

9·In these two modes the data and CLK pins should not be clocked to reduce noise in the captured pressure or temperature data.

在这两个数据和时钟引脚不应时钟频率为减少捕获的压力和温度数据的噪音模式。

10·CLK signal generator with adjustable frequency, gradually changing the frequency of observed changes in scan frequency effect on the output.

CLK采用频率可调信号发生器，逐渐改变频率，观察扫描频率的改变对输出效果的影响。