全部

1·The simplified elastic-plastic analysis was used for the thermal expansion loading.

事故工况下温度载荷对设备的影响采用了简化弹塑性分析的方法。

2·This paper presents the elastic plastic analysis results of mono strand anchor head by the finite element method.

本文采用有限元方法给出了单孔锚具的弹塑性分析结果，分析了摩擦系数对锚具性能的影响。

3·The corresponding elastic-plastic solutions are also obtained by the-engineering method of elastic-plastic analysis.

并用弹塑性分析的工程方法得到相应的弹塑性解。

4·In terms of the calculating theories of the composite steel-concrete beam, the elastic analysis and the plastic analysis are expounded systematically.

在组合梁的计算理论中，作者分别详细地阐述了组合梁的弹性分析和塑性分析理论。

5·Based on plastic analysis and non-linear finite element analysis, the structure's load-bearing capacity under secondary internal forces is calculated and certified.

利用塑性极限分析和非线性有限元分析方法计算并验证了结构在考虑次内力作用时的极限荷载。

6·At the same time, precise structure elastic-plastic analysis method created advantage for the performance-based design method, an advanced aseismatic design method.

同时，精确的结陶弹塑性分析方法也为先进的抗震设计方法——性能抗震设计法创造了有利条件。

7·By comparing the ways of plastic analysis, the plastic moment coefficient and load coefficient are used to illustrate the collapsing load formula of mobile-structure.

本文通过对塑性分析方法比较，采用了塑性弯矩系数和荷载系数来表达机构破坏荷载公式。

8·Next, on the basis of the transient-state thermal analysis, the thermal elastic-plastic analysis of the thermal-structure couple is obtained in the axial symmetry loads.

其次，在喷管轴对称模型瞬态热分析的基础上研究了轴对称载荷下热—结构耦合场的应力分析。

9·The obtained transient temperature field can represent the basic characteristics of the real welding process and can be used as the foundation of thermal elastic-plastic analysis.

该温度场能够反映实际焊接过程的基本特征，可以作为焊接过程热弹塑性分析的依据。

10·Heat-fluid-solid coupling and contact thermo-elastic-plastic analysis was carried for a certain turbine blade-disc, and the stress and strain-time course was obtained in this paper.

采用随机有限元方法， 针对某燃气涡轮盘-片进行了热流固耦合及接触热弹塑性分析， 得到了随机应力应变响应；