全部

1·Composite layer board model is adopted to analyse functionally gradient materials cantilever board.

采用复合材料层合板模型，对梯度功能材料悬臂板进行了分析。

2·The paper adopts composites layer board model to analyse functionally gradient materials cantilever board.

本文采用复合材料层合板模型，对梯度功能材料悬臂板进行了分析。

3·Abstain ambry to often be collected from the market come common layer board had considered as with hardware fittings.

自制橱柜往往从市场上采来普通层板和五金配件就认为是好的了。

4·This paper describes the development successfully of super thin and high multi layer board (MLB) using ink jet technology.

概述了应用喷墨技术成功地开发了超薄型和高多层的多层板。

5·No bolt, install the demolition of convenience, to ensure the controllable pitch. Shelves layers board usage can choose steel layer board, plywood, density board.

不用螺栓，安装拆卸方便，可任意调距货架层板使用情况可以选用钢层板，夹板或中密度板。

6·Best layout and performance are achieved with at least a 4-layer multilayer board, where there is a ground plane layer, a power supply layer, and two signal layers.

电路板至少需要4层才能实现最佳布局和性能：一个接地层、一个电源层和两个信号层。

7·But many of the sunshine board thickness and layers do not understand, if in theory layer must be the more the better?

但许多人对阳光板的厚度和层数不了解，假如从理论上来讲是不是层数越多必定越好呢？

8·Three-dimensional turbulent boundary layer on the ground board is measured through the ground effect tests of a delta wing with aspect ratio 3.

本文通过一个展弦比为3的三角形机翼的地面效应试验，测量了地板上的三元紊流附面层。

9·The measurement results show that there is really a distortional boundary layer displacement surface on the ground board, and it fully differs from natural growing boundary layer on the ground board.

测量结果表明：在地板上确实存在一个畸变的附面层位移面，它与自然增长的地板附面层截然不同。

10·PCB design mostly includes the system's size programming, board layer programming and routing design.

印刷电路板设计主要包括了系统尺寸规划、板层规划和布线设计等等。