全部

1·A new stepless-adjusted jig using worm and worm gear driving is introduced in this article.

一种利用蜗杆蜗轮传动无级调节偏心的双偏心轮定位夹具。

2·This proves that the manufacturing accuracy of worm and worm gear is higher, while the manufacturing methods are feasible.

说明蜗杆螺旋槽以及蜗轮的加工精度是较高的，选用的加工方案是可行的。

3·On the bases of pressure distribution, applied the load on the element, after a large number of computer runs by using ANSYS, obtained the stress distribution on the worm and worm gear.

按照上面所获得的载荷分布规律，把载荷施加在有限元模型上，利用ANSYS计算，得到了应力的分布规律。

4·Our factory hob phyletic annular gear hob, such hob, spline Bob, before shaving, and cut the hob top hob, sprockets hob, also produce all kinds of worm and worm.

我厂生产的滚刀种类繁多比如环形滚刀、蜗轮滚刀、花键滚刀、剃前滚刀、倒角以及切顶滚刀、链轮滚刀、同时也生产各类蜗杆与蜗轮。

5·Based on the vibration measurement and analysis of worm gear reducer, a new monitoring method is put forward for wear of worm and worm wheel.

本文基于蜗杆蜗轮减速器工作中振动信号的测量和分析，提出了一种蜗杆蜗轮减速器磨损状态的振动监测方法。

6·This paper discusses the mesh theory, mesh parameters and strength of ring worm and roller worm gear drives, and provides the calculation formulas for the design of this kind of drives.

本文全面论述了环面蜗杆滚子蜗轮传动的啮合原理、啮合参数及其强度，并提供了设计计算公式。

7·The deformation coordination equation of worm gear for rolling cone worm gearing is introduced, and the formulae of forces analysis and the rolling - and - sliding friction coefficient are given.

本文建立了滚锥包络环面蜗杆传动蜗轮的变形协调条件，给出了该种传动受力分析的计算公式以及蜗轮与蜗杆之间滚滑摩擦系数计算公式；

8·TI worm drive is a novel kind of hourglass worm, which consists of involute helical gear and enveloping hourglass worm.

TI蜗杆由渐开线斜齿轮包络形成，与斜齿轮组成一种环面蜗杆传动。

9·When the worm crisscross Angle, still need to ensure that's too, and worm gear and worm helical screw to must be identical.

当蜗轮蜗杆的交错角为时，还需保证，而且蜗轮与蜗杆螺旋线旋向必须相同。

10·During the cutting of the worm bevel gear, due to the impact interference between the worm and cutter rest slide and screw, the gear teeth shape cutting can not be performed.

蜗杆伞齿轮切齿时，由于蜗杆部分与刀架滑板及刀架螺钉发生碰撞干涉，导致刨齿加工无法顺利进行。