全部

1·The transfer matrix across the shrink fit section is established.

本文导出了热套段模型的传递矩阵表达式。

2·This paper puts forward a method for calculating shrink fit to replace the traditional empirical method.

本文给出一种组合活塞配合间隙(过盈)值的计算方法，可以替代以往单凭经验估算的传统方法。

3·Through analyzing finite element in shrink fit, the application of the contact element in shrink fit is discussed.

通过对过盈装配的有限元分析，研究接触单元在过盈连接中的作用。

4·An engine accident by slipping of shrink fit crankshaft which caused severe damage of two main bearings is analyzed.

对主机曲轴红套滑移，并使二道主轴承严重损坏的机损事故进行了分析。

5·Detailed information on the shrink fit process in laboratory and the experiment data using a full-scale gear-axle piece are...

详细叙述了原尺寸试件过盈联接承载能力的试验方法和试验结果，得出了配合面间摩擦系数的经验公式。

6·The cylindrical surface shrink fit process to match large gears and their axles is practised in the manufacture of large electro blocks HC8 and HC16 now under development.

本文在研制的HC8和HC16大型电动葫芦中，大齿轮与轴之间采用了圆柱面过盈联接。

7·The third shrink fit (10) allows greater torques to be transmitted from the gear (4) to the shaft (2) than the first shrink fit (8) and smaller torques than the second shrink fit (9).

通过第三热压配合部（10）能够将 比通过第一热压配合部（8）更大的转矩和比通过第二热压配合部（9） 更小的转矩从齿轮（4）传递到轴（2）上。

8·The test method employed is non-destructive, so that only one model is needed for investigating stresses in a rotating disc at various speeds, and for determining the static shrink fit stresses.

由于这是一种非破坏试验方法，所以仅一个模型就可以对几种不同转速以及静过盈状态下的应力进行测定。

9·The relative sizes of the turn down rims of the fins were determined for the processing characteristics of square finned tubes, the shrink fit technology program of the casing fin tubes was proposed.

针对方形翅片管加工特点，确定了翅片翻边的相关工艺尺寸，提出了套片式翅片管的热套工艺方案。

10·The fallen angels are entering the magnificent structure of pandemonium, and at one instant all of the angels shrink in order to fit into the building.

堕落的天使们正在进入建筑宏伟的万魔殿，突然，所有的天使们为了适应这座建筑而缩小，无论它有多大。