全部

1·The DEM data of original terrain are obtained by actual measurement.

方法通过实测提取原始地形DEM数据；

2·In the actual measurement also verified the reliability of this unit.

在实际测量中也验证了这种单元的可靠性。

3·Calibrated results of measurement can meet the demands of actual measurement.

校正后的测量结果能够满足实际测量需要。

4·Finally the hardware realization has been given in combination with the actual measurement.

最后，结合测量实际需要给出了其硬件实现。

5·The actual measurement of hydraulic regime of secondary circuit in a residential area is performed.

对某小区二级管网的水力工况进行了实测。

6·The Black arrow on each gauge is an indicator telling us our actual measurement in the given time frame.

每个仪表上的黑色箭头指示的是在给定时间段里我们的实际量化指标。

7·If the dose rate at any time is known by actual measurement, the value at any other time can be estimated.

如果通过实际测量已知任意时刻的剂量率，则可计算出任何其它时刻的数值。

8·By means of actual measurement showed that this scheme acquired rather good effect in the practical production.

经过实际测量表明，这一方案在实际生产中取得了较好的效果。

9·At last, a example was calculated using this articles program, and compared with the actual measurement result.

最后，利用本文的程序对浙医一院医技楼基础进行了分析，并与实测结果进行了比较。

10·Lastly, make some conclusions in the basis of the contrast between calculated data and actual measurement data.

最后，根据计算数据和实际测量数据的对比，得出了几点结论。

实测

1·At last, a example was calculated using this articles program, and compared with the actual measurement result.

最后，利用本文的程序对浙医一院医技楼基础进行了分析，并与实测结果进行了比较。

2·Verifying by the information of actual measurement, the model can be more accurate to preset and regulate parameters, and can realize intelligent control.

经实测资料验证，模型能较准确预置调节参数，实现智能化控制。

3·A state space model is described, the time response of ferrite loaded cavity is proposed and a new digital measuring method devised. Results of actual measurement on model cavity are given.

本文建议了描述铁氧体加载谐振腔时间响应的状态空间模型和一种新的数字式测量方法，并给出了在模型腔上实测的结果。

4·Experimental results demonstrate that the algorithm performance is greatly enhanced compared with the algorithm based on actual measurement.

实验结果表明，该算法较基于实测法的其他任务调度算法在性能上有较大提高。

5·Through comparison with the actual measurement result, it is approved that this calculation system meet the calculation precision requirements of the project.

经与矫直力实测结果比较， 证明该计算体系的计算精度满足工程的要求。