全部

1·Use vernier calliper to measure the length, diameter of nerve root on both sides.

借助游标卡尺测量两侧神经根的长度和直径。

2·Methods: Measuring 1400 permanent teeth with special dental vernier calliper in vitro.

方法：用牙科专用测量尺测量1400个离体恒牙牙颈曲度。

3·Because of the strict requirement, the length must be measured with a vernier calliper.

由于要求严格，这个长度必须用游标卡尺来量。

4·This paper presents the structure of the electronic calliper gauge and analyses the principle error.

介绍了电子卡规的结构，分析了原理误差。

5·The utility model discloses a combined calliper, belonging to the technical field of the measuring tool.

本实用新型属于测量工具技术范畴。

6·The expanding spring brake-piston damping plates and brake calliper fastening screws must be replaced whenever the brake pads are changed.

更换制动片时，应同时更换扩张弹簧、制动活塞减震板和制动卡钳紧固螺钉。

7·The height of crowns, the center height of clinical crowns, and the width and length of the dental arch were measured with a digital vernier calliper.

用数显游标卡尺测量实验组模型牙冠高度，牙弓宽度和长度，计算出临床冠中心高度，并与对照组进行对比分析研究。

8·In this paper accuracy of sensory certification and relative certification of surface, roughens for calliper planes measured using comparison samples was analyzed.

本文分析了卡尺测量面表面粗糙度感官检定和与比较样块比较检定的准确率。

9·Through the analysis, this article introduces an accurate and speedy measuring method for the working dimension of the calibrating rod used for the thread calliper.

通过对比分析，介绍一种应用广泛、检定准确、适用快捷的螺纹千分尺校对用量杆工作尺寸测量方法。

卡钳

1·The expanding spring brake-piston damping plates and brake calliper fastening screws must be replaced whenever the brake pads are changed.

更换制动片时，应同时更换扩张弹簧、制动活塞减震板和制动卡钳紧固螺钉。