全部

1·The optimum electrolytic corrosion process has been selected through observations.

通过观察比较，找出了最佳电解腐蚀工艺。

2·It is shown that the AC electrolytic corrosion process in a corrosive is a easy way to prepare metallographic specimens of iridium material.

实验表明，在腐蚀介质中进行交流电解是铱材金相制作的快捷之路。

3·The effect of corrosive factors (current, voltage and time etc. )on the result of AC electrolytic corrosion of PM iridium specimens in a suitable corrosive is discussed.

探讨了在适当的腐蚀介质中，对粉末冶金铱材样品进行交流电解腐蚀时，腐蚀因素（ 电流、电压、通电时间等）对腐蚀效果的影响。

4·The paper discusses that the electrolytic corrosion caused by binding cast iron with sulfur adhesive in the open air can be prevented by balancing electrode potential and sealing cover.

分析了硫磺胶在露天粘接铸铁引起的电化学腐蚀，提出了在金属粘接中应用平衡电位和罩面密封以防止电化学腐蚀。

5·The severe corrosion of stainless steel fastening bolts on Electrolytic Galvanizing Line(EGL)in cold strip mill plant under current working conditions has been studied.

采用浸泡、电化学、模拟试验以及拉伸试验对冷轧厂电镀锌机组不锈钢紧固螺栓在现行工艺条件下遭受严重腐蚀进行了研究。

6·The anode corrosion rate by electrolytic polarization is dependent on the condition of test.

电解极化条件下的腐蚀结果与不同的试验条件相关。

7·Temperature had great effect on the storage reliability of aluminum electrolytic capacitors. Corrosion rate of lead was accelerated when the temperature was higher than 40.

环境温度对铝电解电容贮存可靠性有重要影响，温度超过40益引脚腐蚀速度会大大加快。

8·Causes of the stray current corrosion in inlet and outlet of the electrolytic bath were analyzed to put forward a solution.

分析了电解槽进出口系统各主要设备杂散电流产生原因，提出了针对性的解决方案。

9·The results showed that corrosion of lead and molds of rubber plug occurred on aluminum electrolytic capacitors in hygrothermal environment.

结果表明，铝电解电容在湿热环境下出现了引脚腐蚀和橡胶塞长霉的失效现象；

10·The effect of corrosion process on performance of electrode foil used in mesohigh voltage aluminum electrolytic capacitor in sulfuric acid-hydrochloric acid corrosion system was investigated.

采用硫酸-盐酸腐蚀体系研究了中高压铝电解电容器电极箔多段腐蚀方法。