全部

1·The experimental results show that the rate of wear has the same varying tendency under different wear conditions.

结果表明，在不同磨粒磨损条件下，马贝复相组织的磨损率具有相同的变化趋势。

2·The experimentation shows that hardness and wear show non linear relation. The rate of wear depends on many factors.

试验表明硬度与其磨损率呈非线性关系，磨损率是由多因素决定的。

3·A plunger type quantitative lead pump belongs to the technology field of special pumps and is used for solving the problems with the lead pump, including high rate of wear and short service life.

一种柱塞式定量铅液泵，属特种泵技术领域，用于解决铅液泵磨损速度快、寿命低的问题。

4·Increased wear of hard disks, leading to an increased failure rate.

提高了硬盘磨损，导致了故障率增加。

5·If patients do experience a decreased ROM as a consequence of impingement, then subluxation and edge loading may occur, which can lead to a higher wear rate and early failure.

如果病人感觉到降低活动度是撞击的结果，然后半脱位和边缘负荷可能发生，这能导致更高的磨损率和早期的失败。

6·By investigating the relations of hardness difference to wear rate, the best friction pair mate was ascertained.

研究了配副硬度差与磨损率的关系，根据这种关系确定了最佳配副组合。

7·While giving other parameters, wear rate increases along with the increase of contact area.

当其余各影响参数保持一定值时，磨损率随接触面积的增大而增大。

8·The wear rate of EMP increased with increasing of velocity and load at different rates under various test conditions.

EMP磨损率随滑动速度和载荷的升高耐增加，但不同试验条件的增幅不同；

9·It was found that the wear rate evidently decreased with the increase of silicon content. Densification treatment could further improve the wear resistance of the aluminum based composites.

结果表明，随着基体中硅含量的增加，复合材料的磨损率大大降低，另外，致密化处理可进一步改善铝基复合材料的耐磨性能。

10·A peak of the wear rate under certain velocity was found.

发现在一定滑动速度下磨损率有一峰值。