全部

1·Blower system of air knife: the piping from Blower station to air knife.

气刀的风机系统：从风机站至气刀的管道。

2·The paper analyses the main reasons of the vibration of the gas blower, the fault model and mechanism of the vibration of blower system.

研究了引起煤气鼓风机组振动的主要原因，风机系统的故障模型和振动机理。

3·Combined with the work principle and control target of the blast furnace blower system, the construction and the general design project of the control system are put forward.

结合高炉鼓风机系统的工作原理和控制目标，提出了高炉鼓风机控制系统的结构和总体设计方案。

4·Digital signal processor (DSP) was adopted to design portable rotating air blower fault diagnosis instrument, and the system hardware structure and the software designing ideas were expounded.

以数字信号处理器DSP研制便携式旋转风机故障诊断分析仪，并详细阐述了系统的硬件结构以及软件设计思想。

5·The paper also describes its application in combination with the features of a low voltage auxiliary system produced by the Shaanxi Blower(Group) Co.

结合陕西鼓风机（集团）有限公司生产制造的风机机组低压辅机系统的特点，阐明了电动机软启动装置的应用。

6·This paper discusses the method of parameter design technology in developing TLT Blower CAD system.

该文介绍了运用参数化设计技术进行离心风机CAD系统软件设计的方法。

7·Against the problem of oil system in turbine blower, the reason has been analyzed, and the improvement measures have been taken.

针对汽轮鼓风机组油系统存在的问题，分析了原因并对其采取了改进措施。

8·In a coal gas blower set for condensation were incorporated D750 28 blower and speed up hydraulic coupler to adjust load as well as computer control system.

煤气冷凝鼓风机组技术改造选用D750 - 28型鼓风机，采用增速型液力偶合器调节负荷及计算机控制系统。

9·The traditional method is using the blower to decrease the temperature, which will make the change of the temperature in wider range and larger the error of the shifter in the array system.

传统方法采用风机通风进行降温控制，使阵面中温度变化范围较大，造成移相驱动器的移相误差加大，影响雷达天线的性能指标。

10·The design of both software and hardware of the computer control system for the blast furnace centrifugal blower are introduced.

介绍了高炉离心式鼓风机计算机控制系统的软、硬件设计。