全部

1·Its resilience is strong during shaping, because titanium's ratio of yield limit to elasticity modulus is high.

由于钛的屈服极限与弹性模量的比值大，使钛成型时的回弹能力大。

2·Under the instantaneous strain and yield limit calculated, judgement rule about viscoelastic and viscoplastic is established.

通过计算瞬时应变的大小与屈服限建立粘弹性变形和粘塑性变形的判断准则。

3·The initial yield pressure of the cylinder is gained by analyzing the experimental data, and then the yield limit is calculated.

通过对该试验数据的分析得到了圆筒的初始屈服压力，最终求得了材料的屈服极限。

4·Though the peak value of the stress in part areas exceeds the yield limit of the cast steel, as the yielding areas are small an.

线弹性及非线性分析结果表明，最不利工况下，部分节点局部区域的峰值应力有超过铸钢屈服极限的情况，但屈服区域范围小，同时最大应变值尚小。

5·In two and three dimensions the yield limit is reached when a certain function of all the stress components reaches a fixed value.

在二维或三维的情况下，屈服极限是当所有应力分量的某个函数达到某一固定值时达到的。

6·The main reason of the main beam down deflection was that the most complex stress exceeded the admissible value and achieved the yield limit value.

主梁下挠变形的主要原因是受热引起的最大复合应力超过许用值，达到了屈服极限值，强度不满足要求。

7·The most dangerous point is at the root of the first engaged tooth of a joint. Generally, the biggest values of stress and strain may exceed the yield limit.

最危险点在接头的第一啮合齿的齿根处，最大应力应变值一般均超过屈服极限。

8·To make automobile panel rapidly and accurately, the yield limit, hardening modes and invalidation modes of materials for large automobile panels were analyzed.

为了快速、准确地制造汽车车身覆盖件，对大型汽车覆盖件材料的屈服极限、强化模式以及失效模式进行了分析。

9·Increasing the yield limit of high strength steel, and increasing the depth of submergence, the form of the differential equation's result will not only be limited with the complex number.

由于高强度钢材的屈服极限不断地增大，下潜深度的不断增加，弯曲微分方程解的形式将不仅限于复数解。

10·Some ideas on improvement in prestressing process are raised according to the observation and analysis on modulus of elasticity, apparent yield limit, tensional strength and percentage elongation.

根据对弹性模量、非比例强度、抗拉强度和断裂伸长率的观察分析，提出了预应力钢丝张拉施工工艺的改进意见。