全部

1·To design the eraser, grab the rounded rectangle tool and draw a small rectangle with an edge radius of 1px.

设计橡皮擦，抓住圆角矩形工具，画一个小矩形的边缘半径1px。

2·The two basic precision requirements for ultra precision diamond cutting tool are the precision of outline and edge radius.

超精密金刚石刀具的两个基本精度要求是刀刃轮廓精度和刃口半径。

3·By researching relation between cutting edge radius and force to cut synthetic fiber it develops a technique for measuring the sharpness of tools.

通过研究刀具刃口半径与刀具切断纤维的力之间的关系，提出了一种检测加工刀具锋利性能的方法。

4·The result shows that the cutter blade edge radius, edge angle, the linear abrasion and the edge notch depth are main factors affecting its sharpness.

分析结果表明， 纤维切割过程中，切断刀锋利性能的变化主要与切断刀的初始刃口半径、刃口角度、刃口的磨损量以及刃口上缺口的深度有关。

5·The paper describes several practical method for measuring the edge radius of the tool after resharpening and looks foward to the development of the edge radius measuring technique.

详细叙述了对刃磨后刀具刃口半径检测的几种可行方法，展望了刃口半径检测技术的前景。

6·The radius is 85 centimeters and the arc to the edge is about 20 centimeters.

半径是85厘米，弧线到边缘是，大约20厘米。

7·Join the surfaces and use fillet edge command with proper radius size.

加入表面和使用圆角边指挥适当的半径大小。

8·If I look at something that goes as n squared, if this is the edge of the nucleus here and if this is r1, 4 it says when n goes to two the radius goes to four.

如果在原子核外侧,我们发现某一半径和n的平方成正比，也就是说当n为2时半径等于。

9·Corner Area: the edge line with the goal line cross, have a dot, radius is 1m, drawing a quarter of circle arc.

角球区：以边线和球门线交叉点为圆点，以1米为半径，向场内各画一段四分之一的圆弧，这个弧内地区叫角球区。

10·According to double radius method and edge bend method, this paper introduces the design theory of roll pass with opposite direction bend in middle part for cold forming of round pipe.

本文在双半径法和边缘弯曲法的基础上，介绍了一种冷弯圆管的中部反向弯曲孔型设计理论。