全部

1·If you change the reflected load impedance, you will find yet another optimum spot.

如果你改变了反映负载阻抗，你会发现又一个最佳位置。

2·The main reasons of the breakdowns are the changes of load impedance and disturbance signal.

认为负载阻抗的变化和干扰信号是造成故障的主要原因。

3·This paper proposes a fast method of computing PVZ curves using load impedance as dynamic step.

提出了一种基于阻抗动态步进的PVZ曲线快速求解方法。

4·Secondary load impedance of a current transformer(CT) has great influence on the error of the CT.

电流互感器二次负载阻抗对电流互感器误差有较大的影响。

5·Also, the relationship between the input impedance and load impedance of the waveguide is discussed.

讨论了波导管输入阻抗与负载阻抗之间的关系。

6·The actual signal distortion levels depend upon input and output signal amplitude, as well as the output load impedance.

实际的信号失真水平取决于输入和输出信号的幅度，以及输出负载阻抗。

7·The design method of the high voltage and the fast response time pulse transformer used in the condition of low load impedance was introduced.

介绍了工作于低阻抗负载下的高压大电流快响应脉冲变压器的一种设计方法。

8·The calculation result on a 5 bus system shows that the new power flow algorithm based on constant load impedance can get more reasonable solution.

研究结果表明，电炉、电镀和电解等纯电阻性或近似电阻性负荷以恒定阻抗模型表示，潮流计算结果更加符合电力系统实际运行情况。

9·Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.

由于直流电压源的钳位作用，交流侧输出电压波形为矩形波，并且与负载阻抗角无关。

10·Depending upon the transformer and storage capacitor sizes in the power supply the output voltage will not vary significantly when the load impedance is changed.

由于变压器和滤波电容(假定)足够大，因此当负载阻抗改变时供电电压几乎没有变化。