全部

1·It's important to put a lock washer on that last nut, or it can work loose.

重要的是要在最后一个螺母上安装一个防松垫圈，否则它会逐渐变松。《柯林斯英汉双解大词典》

2·The two-piece Hard Lock Nut is easy to install, requiring only the use of a wrench.

双件套强力锁紧螺母安装简便，只需要一个扳手就行。

3·After completing adjustments, tighten the lock nut and replace the fast fill lever cap.

在调节完成后，紧固锁紧螺母，重新安装快速进水手柄帽。

4·Revolving the lock nut 5 anti-clockwise to the suitable position.

逆时针方向旋转锁紧螺母5，使其退到适当位置。

5·Remove the fast fill lever cap, and loosen the lock nut.

拆卸快速进水手柄帽，松开紧锁螺母。

6·NOTE: If minor leakage occurs, remove lock screw, lock washer and cap and lightly tighten packing gland nut.

注：如果出现少量的泄漏，则拆卸锁紧螺丝，然后锁住垫圈和阀盖，然后轻轻紧固填料压紧螺母。

7·Hold stem (27) on wrench flats and remove nut (51), lock washer (46), diaphragm plate (60) and diaphragm.

在扳手的平面上握住阀杆(27)并拆卸螺母(51)，锁紧垫圈(46)，隔膜板(60)和隔膜。

8·In connection with the bottom cable hand brake handle (usually from the interior cover) has an adjustable offset, with wrench to loosen the lock nut, can stretch brake cable length.

在手刹手柄的底部与钢缆的衔接处(通常由内饰件掩盖)有一个可调的抵偿组织，用扳手松开锁紧螺帽，就能够拉伸刹车钢缆的长度。

9·They are made up of sleeve, lock nut and lock washer.

它由称套、锁紧螺母、锁紧垫圈组成。

10·Loosen and remove the diaphragm lock nut and lock washer, pressure plate and diaphragm from the valve stem.

松开和拆卸隔膜锁紧螺母和锁紧垫圈，从阀杆上往下压阀盘和隔膜。