全部

1·The formula of wedge angle is deduced under the condition of two-beam interference.

在考虑双光束干涉的情况下，导出测量平板楔角的公式；

2·The circle does not necessarily need to touch the fitting lines nor is its centre necessarily on the wedge Angle bisector.

圆圈，纷歧定需求以接触拟合直线也必然是此中心的楔角等分线。

3·This Paper Presented a simple method for measuring wedge Angle between end-faces of crystal bar used in microwave delay lipe.

本文介绍了一种简便的测量微波延迟线所用晶棒两端面间楔角大小的方法。

4·The method is suitable for small angle with a measurement error of about 1%. The wedge angle calculating equations are given.

该方法引入的测量误差约为1％，且它适于小角度测量。

5·The radiation angle and the given dose for each field were derived from this equation. The wedge angles of each field were got.

利用靶区剂量分布均匀时每个野的照射角及应给的剂量，由此求出楔形滤板应取的楔形角。

6·This instrument can also measure the refractive-index homogeneity, the flatness, the Angle error, the wedge Angle of crystal element.

仪器还可测量晶体材料折射率均匀性、晶体元件面形、角度、平行度等。

7·The influence of the small wedge Angle of the plane parallel plate and the lateral shearing width upon judging laser collimation are discussed.

分析了准直原理，讨论了平行平面板楔角和横向位错宽度对准直判断的影响。

8·Gate has two sealing surfaces, the most commonly used wedge gate valve sealing surface to form two wedge-shaped, wedge Angle parameters vary with the valve.

闸板有两个密封面，最常用的楔式闸板阀的两个密封面形成楔形，楔形角随阀门参数而异。

9·The numerical examples are provided to show the influences of the material properties, the wedge Angle, dislocation position and the crack length on the interaction.

最后通过数值算例，针对不同问题讨论了材料常数、楔口角度、裂纹长度对相互作用的影响。

10·The wedge angle bisector gives as intersection with the cutting edge profile point pint. (3) Draw a circle that intersects point pint and is tangent to both straight fitting lines.

这 楔角的等分线给作为路口停止切割 边缘轮廓点品脱的啤酒。 （3）画一个圆订交点，两品脱和相切 直线拟合直线。