全部

1·I need a delta — an acceptable amount for arithmetic error.

需要一个delta——可接受的算术错误的量。

2·Because wib is in frame 0 that's the function the program was executing inside when the arithmetic error occurred.

由于wib在0号帧中，那么它就是执行程序时发生算术错误的函数。

3·GW dry contact model, which results in the unacceptable error in engineering, has 5 shortcomings in the arithmetic.

GW干接触模型在算法上存在5个缺陷，会引入工程上无法接受的误差。

4·This error is reported when the result of an arithmetic operation is outside of its supported range.

当算术运算的结果在它的支援范围的外面时候，这一个错误被报告。

5·In the paper presents the predictive out of a new generalized predictive Control is corrected by the error predictive model based on a new excite function BP arithmetic.

本文提出基于新的激励函数BP算法建立误差预测模型，修正新型广义预测算法的预测输出。

6·This paper gives a method to calculate the arithmetic square root by iteration with given accuracy, analyses the iteration error and provides a selected range of initial value with the given accuracy.

本文给出了在预定精确度下用迭代法计算算术平方根的方法，并分析了迭代的误差，给出了预定精确度下初始值的一个选取范围。

7·An arithmetic overflow error occurred while resolving the column values.

在解析列值时，发生算术溢出错误。

8·In other words combination of two arithmetic operations may produce rounding error that significantly exceeds 2 epsilon.

换句话说，两个操作操作的组合可能会产生显著超过2倍精度的误差。

9·Image datum mark distinguishing, wear counting and gauge, error analysing are researched and the arithmetic are coded in image analysing part.

在图像分析中，对图像基准点判别，磨耗和轨距计算，误差分析等问题进行了研究和算法编程。

10·The measurement error source of center of cone gravity, arithmetic and uncertainty of ATS are given, and the measurement accuracy of cone center of gravity is improved.

着重分析了锥体重心测量系统测量误差的来源、算法及系统整体测量不确定度的评定，从而可以提高锥体重心的测量准确度。