全部

1·Cone air lock valve can realize to discharge dust with the help of torque balance.

锥形锁风阀利用力矩平衡的方法实现卸灰。

2·Based on the single DC motor model, the mathematic model of dual-motors was established to analyze the problem of output torque balance of dual-motors.

这一特殊结构使得正反转电机的驱动问题尤其是输出转矩平衡问题显得尤为突出。

3·Because of this torque balance, ensure the valve opening and the corresponding relationship between the input signal accurately to achieve the correct positioning of the spool.

水力控制阀由于这种力矩平衡，保证了调节阀开度与输人信号之间对应关系准确，实现了阀芯正确定位。

4·Lifting operation hydraulic system should be no-load operation, adjust the lifting sleeve frame roller and the mast section clearance, hoisting torque and balance torque balance;

顶升作业时液压系统应进行空载运转，调整顶升套架滚轮与塔身标准节的间隙，使起重力矩与平衡力矩保持平衡；

5·For more information on Balance and Torque, refer to the links under Job management in Resources.

要获得更多关于Balance和Torque的资料，请参阅参考资料中“作业管理”部分的链接。

6·Balance weight block installation position is not accurate, will cause the boom and the balance arm balance torque deviation is too large, easily lead to instability of the tower crane.

平衡重块安装位置不准确，会造成起重臂与平衡臂平衡力矩偏差过大，轻易造成塔吊失稳。

7·The methods of load balance of moment limiting and speed softening mode under torque control model and velocity mode are put forward.

提出了在转矩模式、速度模式下力矩限幅和速度软化方式的负荷平衡方法。

8·In view that large top torque and negative torque are produced when crank balance (primary balance) is adopted, we present the secondary balance of beam pumping unit.

针对游梁式抽油机在采用曲柄平衡(又称一次平衡)时存在的峰值转矩较大、负转矩严重等现象，提出了有关抽油机的二次平衡问题。

9·Plastication torque, balance torque and processing energy consumption at the condition of single-screw processing are larger than those of double-screw processing condition.

单螺杆挤出材料的塑化转矩、平衡转矩和加工能耗均较双螺杆的略大。

10·The characteristic of the torque and power loses are analyzed under the performance of unbalance operation, a current balance control method is brought forward and the experimental results are given.

分析了该电机工作在各种不平衡状态下的转矩与功率损耗的特性，提出了一种电流均衡控制方法，并且给出了试验结果。