全部

1·This paper presents the principle of PWM based on flux linkage locus control.

分析了磁链轨迹跟踪pwm控制的基本原理。

2·The air gap flux linkage is a linear function of stator current and mover displacement.

气隙磁链是定子电流和动子位移的线性函数。

3·Then using fuzzy algorithm with phase current and flux linkage as inputs, the rotor position can be detected.

在此模型的基础上，运用模糊算法，以电流和磁链作为输入、位置作为输出，检测出转子的位置。

4·Thus during the modelling of the inverter, it is proposed the compensate algorithm with equivalent flux linkage.

针对这些问题，在逆变器建模过程中，提出了一种等磁链电压补偿算法。

5·According to the inner rim rotor flux linkage given value can reach the purpose of the energy optimization control.

根据外环给定电磁转矩的不同，调整内环转子磁链给定值，以达到能量优化控制的目的。

6·By placing auxiliary gauge-winding on the stator pole and adopting hardware integrator, the flux linkage is measured.

该方案通过放置辅助检测绕组和采用硬件积分器，对电机绕组磁链进行实时检测；

7·Flux linkage equation is constituted, the electromagnetic transient of voltage equation with constant speed is gained.

建立了磁链方程，得到了转速为常值时电压方程的电磁瞬态解。

8·U-I flux linkage model can be set exactly at low speed for considering the effects of temperature to stator resistance.

由于考虑了温度对定子电阻阻值的影响，提高了u-i模型在低速运行时磁链观测的准确度。

9·This paper discusses the locus of flux linkage under soft-switching PWM pattern by using space voltage vector in detail.

该文利用空间电压矢量概念，深入分析了软开关pwm模式下磁链的运动轨迹。

10·Utilizing flux linkage and phase current, the output torque is calculated, and PID control is used to decrease torque error.

结合绕组电流进行转矩估算，经过转矩误差pid反馈控制，实现电机输出转矩对转矩给定指令的跟踪。