全部

1·Pump axial force and radial force by the rolling bearing box to bear.

泵的轴向力与径向力分别由轴承盒内的滚动轴承来承受。

2·Expressions of radial force and torque variance were obtained by analytical method.

用解析的方法，给出了径向力和切向力随时间变化的具体表达式。

3·The time-dependent change of leakage rate and radial force of interface was analyzed.

研究了泄漏率、耦合面径向力随时间的变化情况；

4·The large radial force is the important factor of affecting the service life of the cylinder.

过大的径向力是影响液压缸使用寿命的重要因素。

5·An analysis on the affection of pre-tightened radial force and its optimal value was carried out.

对径向预紧力的作用和最佳数值进行了分析。

6·The conclusions show that the radial force and torque change in cyclic periods during the transmission.

结果表明，外场驱动血泵在啮合传动过程中，径向力和传递扭矩均是周期变化的。

7·The linear power amplifier of current-type and the PIDcontroller is designed for the control of radial force.

针对径向力的控制要求研制了双向电流型线性功率放大器和PID控制器。

8·Too much deflection was induced by the radial force, which resulted in the excessive machining error to the gear.

在径向力作用下，顶尖前端部产生过大挠度，造成齿轮加工误差过大。

9·If use the belt wheel, wheel, etc, shall set bracket support, in case of driving gear bearing by the radial force.

若用带轮、链轮等驱动时应设托架支承，以防主动齿轮轴承受径向力。

10·Firstly, the improved method judges whether the needed radial force and the torque can be simultaneously satisfied.

改进算法首先对给定的悬浮力和转矩是否能够同时满足进行了判断。