全部

1·The model is also extended to involve the isotropic and kinematic hardening or softening.

该模型具有考虑各向同性和运动硬化、软化的功能。

2·A modified associated flow rule of plastic strain for kinematic hardening materials is presented.

提出一种修正的随动硬化材料塑性应变关联流动律。

3·Finally, the shakedown problems of rotating disks of such materials under isotropic and kinematic hardening conditions are discussed.

文中最后讨论了各向同性强化条件和随动强化条件下两种材料旋转圆盘的安定性。

4·Kinematic hardening model was used in FEM analysis and the response behaviors of transient local stress strain for material was also considered.

有限元分析采用了随动强化模型，并考虑材料瞬态局部应力应变的响应特性。

5·The (aeolotropism) and Bauschinger effect resulted from plastic deformation under cyclic loading were reflected by the kinematic hardening model in the SFEM.

针对复杂的交变载荷，采用运动强化模型反映塑性应变引起的各向异性和包辛格效应。

6·In this model, a new kinematic hardening equation was used; the non-proportionality, the effect of temperature and memorization for the maximum plastic strain amplitude were also considered.

该模型给出了一个新的背应力演化方程，引入了非比例度参量，并且还考虑了最大塑性应变幅值记忆效应和温度效应的影响。