全部

1·Evaporation temperature is high, low pressure is high.

蒸发温度高，低压压力也高。

2·It can also be shown that there exist an optimum evaporation temperature at which a maximum deh...

而且热泵干燥系统存在一个最佳的蒸发温度，可使系统除湿率和效率最大。

3·The evaporation temperature has negligible effect on the average evaporation heat transfer coefficient at the same oil concentration.

同一含油率下，蒸发温度对平均换热系数影响不大。

4·However, the Formamide without any smelling, even it is heated to the evaporation temperature, it still will not produce any ammonia that can be smelt.

但是甲酰胺没有味道，加热到蒸发的温度也不会分解产生有味道的氨出来。

5·To raise the juice evaporation temperature in the first effect and avoid the sugar loss in process meanwhile, the ICDFE should be the new kind of equipment to choose.

认为．要想提高首效糖汁的蒸发温度，同时又要避免工艺过程中的糖分损失，内筒式直流蒸发罐将是一种新型的设备供选择。

6·Experimentation analysis of the influence of the openness of the expansion valve and evaporation temperature on the capability of the heat pump dehumidification in this paper.

对除湿机膨胀阀开度和蒸发温度对除湿机性能的影响进行了实验分析。

7·Results from the experiment show that there exists a maximum coefficient of performance and it depends on the evaporation temperature and outlet temperature of the gas cooler.

实验结果表明，系统运行时的最大制冷(热)系数取决于系统的蒸发温度和气体冷却器出口温度。

8·The influence of preparation parameters, such as solvent, the concentrate of LCP, PS, addictive, evaporation temperature and time, on the properties of UF membrane were studied.

考察了相关制膜参数如溶剂、高分子液晶的浓度、聚砜的浓度、添加剂的用量、蒸发温度和蒸发时间等对超滤膜性能的影响。

9·The influences of generation temperature, evaporation temperature, absorption temperature to the coefficient of performance, circular ratio and cooling capacity were also studied.

并讨论了循环的发生温度、蒸发温度、吸收温度对循环性能系数、循环倍率和制冷量的影响。

10·Based on the low evaporation temperature of organic semiconductors, a radioactive heater-crucible assembly was developed for vacuum evaporation coating and sputtering coating systems.

针对有机半导体材料的蒸发温度低的特点，设计并制作了低温辐射式加热器。