全部

1·The article researches the application of CCD in the measuring of young modulus.

本文研究CCD在杨氏模量测量中的应用。

2·The maximum stress, strain at rupture, and Young modulus were obtained for each group.

获得每组标本的最大断裂应力、应变和杨氏模量。

3·The measuring principle of sensor PSD is introduced and the system for measuring Young modulus that is based on PSD is described in this paper.

介绍了PS D位置传感器的检测原理和一种基于PSD的钢丝杨氏弹性模量测量系统。

4·Through the two different methods, this paper discusses how to develop the experimental simulation software: tensile test, compressive test, strain measurement of Young modulus and Poisson ratio.

通过以上两种不同的模拟方法，本论文分别阐述了拉伸破坏实验、压缩破坏实验以及电测法测定材料弹性模量和泊松比的仿真软件设计与开发的方法。

5·Using Young modulus of apparatus, the hysteresis property of tension exerted by steel wire is analyzed, the experimental way and theoretical principle are provided to check the quality of springs.

利用杨氏模量测定仪对钢丝力的滞后特性进实验分析，为减少实验误差和检验弹簧的好坏提供了一种实验途径及理论依据。

6·I know Young 'modulus for the bubble wrap, so I can find the spring constant as.

我已经知道了汽泡纸的杨氏模量，因此通过以下表达式我可以计算出它的弹性系数。

7·Based on the theory of Fraunhofer diffraction, an improved method is introduced to measure Young ' s modulus of steel wires using CCD.

根据夫琅和费衍射原理，采用CCD来测量金属丝在拉力作用下的微小伸长量，对钢丝的杨氏模量进行了测量。

8·The longitudinal yield strength and the Young′s modulus increase with the draw ratio.

纵向屈服强度和模量随拉伸比增加而提高。

9·As comparing with adopting traditional optical lever method to measure Young 's modulus of elasticity E. Using optical sensor is much better in both operation and data precision.

对杨氏弹性模量E用反射式位移传感器与传统的光杠杆法测量进行比较，得出无论从操作方面还是数据的精确度方面都说明了光纤传感器法大大优于光杠杆法。

10·When the sample is at the stage of grinding damage, the axial force and torque are related to the Young? S modulus, cohesion and internal friction Angle except the compression strength.

而处于研磨阶段时，轴向压力、扭矩和试样弹性模量、黏聚力及内摩擦角有关，与抗压强度无关。