全部

1·By adopting ATEQ F520 instruments and electronic governing valve the engine cylinder cc sealing detection.

通过采用ATEQ F520仪器及电子调压阀对发动机缸体缸盖进行密封性检测；

2·The stability of steam turbine control system could be effected by the governing valve nonlinear position-flow characteristic.

调节阀特性非线性将影响机组的稳定运行，必须通过非线性补偿，使机组的静态特性线性化。

3·There is difference attitude about whether it is necessary to open all the governing valve in sliding pressure operating mode.

滑压调节时是否有必要全开所有的调节阀，还是可以仅仅全开部分的调节阀运行，国内在理论上对此存在着分歧。

4·Pressure governor valve is composed by governing valve, oil, water separation devices and a combination of one - way valves, etc.

调压阀是由调压阀、油水分离器及单向阀等构成的一个组合阀总成。

5·A governing valve is the instrument for changing flow resistance and heat transfer flux of hot water, controlling pressure and temperature of heating system.

在热水供暖系统中，调节阀是改变热媒流动阻力、传热量变化及控制系统的调节装置。调节阀的选型、使用涉及多方面知识。

6·The balance valve which is one of governing valves can conveniently change flow resistance of hot water, improve the regulating ability and keep the safety of heating system.

根据平衡阀的工作特点，使用它能合理地改变供暖系统的流动阻力，改善供暖系统的调节功能，保证了供暖系统工作的稳定性。

7·Through dealing with and analyzing the jam phenomenon of steam make-up governing valve of 9e combined-cycle steam turbine, the corresponding resolutions and preventive measures are put forward.

通过对9e联和循环汽轮机补汽调门卡涩现象的处理和分析，提出相应的解决和预防措施。

8·Liaocheng power plants 600mw unit cant perform the switching operation from governing valve mode to sequence valve mode, which has long been a problem and affected the unit efficiency apparently.

聊城电厂600 MW机组投产以来一直存在调节阀无法切顺序阀运行问题，对机组的效率影响较大。

9·Combine a body the pump and the valve, and through pump's by-pass governing, causes the return route pressure to drop to lowly, thus reduces the pipeline and divulging.

将泵和阀组合成一体，并通过泵的旁通控制，使回路压力降至最低，从而减少管路及其泄漏。

10·The failure of valve opening sensor would cause valve management of DEH system working confusedly, and result in large scale change of turbine power in the case of governing stage pressure loop idle.

DEH系统中阀位传感器的故障会给阀门管理带来混乱，特别在调节级压力回路未投入的情况下会引起汽机功率的较大变化。