全部

1·This measurement will give you the propeller shaft Angle (C).

测量结果就是传动轴工作角(c)。

2·Varus mal reduction was defined as a head - shaft angle of 120 degrees.

内翻复位不良按头- 干角120度为标准。

3·The shaft angle encoding and digital display of an optoelectronic tracking system is introduced in the paper.

介绍一种光电跟踪系统所采用的轴角编码与数字显示器。

4·The drive software of the shaft angle synchro converter has been applied in a weapon automatic testing system.

该轴角同步器驱动软件已应用于某装备综合自动测试系统。

5·Exerting data combination and data correct theory of two-speed shaft Angle converter, it researches a new type two-speed processor based on shaft Angle conversion monolithic of RD-19230.

运用双速轴角转换原理中的数据组合与数据纠错原理，基于轴角转换芯片rd - 19230，研究一种新型的双速处理器。

6·The choice of the tunnel shaft Angle should be within a certain reasonable limits, and the chosen of the inclined shaft is flexible depending on the specific project conditions of the tunnel.

隧道斜井倾角的选择应在一定的合理范围内，视隧道的具体工程条件灵活取用。

7·The thesis presents a practical die structure with Angle pin and gear shaft and rack for secondary combined inclined down loosing core of die casting hopper bodies.

本文给出了浮子室体铸件斜销-齿轴-齿条二级联合斜下抽芯压铸模实用结构，论述了模具结构特点和工作过程。

8·Commonly used servo motor is ac servo motor, the motor shaft with in the photoelectric encoder, by detecting the rotor Angle to frequency conversion control.

常用的伺服电机是交流伺服电机，在电机的轴端装有光电编码器，通过检测转子角度用以变频控制。

9·The strut has a positive angle when the prop shaft points upwards towards the water surface.

高视阔步有一个正面角度当支柱轴指向向上往水表面。

10·There must be one or more universal joints to permit variations in the Angle of drive. there must also be a slip joint that permits the effective length of the propeller shaft to change.

一个或几个万向节来适应传动角度的变化；一套伸缩花键，能够改变传动轴的现有长度。