全部

1·The control rule base in the form of linguistic rule is given.

控制规则库以语言规则的形式给出。

2·The way may realize self learning multi dimension control rule base.

方法能实现任意维控制规则库的自学习。

3·The fuzzy control rule for the calculation of quantization gain factor is given.

确立了计算量化增益因子的模糊控制规则；

4·The dynamic response and control rule of the system were analyzed by this model.

初步分析了该系统的扰动特性、调节特性和控制规律。

5·Moreover, the solutions to control rule and cutting tool management are presented.

同时，提出了任务调度规则和刀具管理的设计方法。

6·The self-optimizing method of the fuzzy control rule model has been presented finally.

最后给出模糊控制规则模型自寻优优化方法。

7·Closed loop feedback adopts PID control rule to insure the stabilization of magnification times.

闭环反馈采用PID这种最广泛使用的控制规律，以保证放大倍数的稳定。

8·On the basis of generalized minimum variance control principles, an expanded control rule is induced.

以广义最小方差控制原理为基础导出了扩展控制规律。

9·Based on the optimal control theory, the energy saving control rule, the on-off switching manner, is derived.

在此基础上，根据最佳控制理论，导出了节能控制规律——开关控制。

10·The design principles of the control rule base under common conditions for non-minimum phase systems is proposed.

并针对非最小相位系统，提出了一般情况下控制规则基的设计原则。