全部

1·The durableness problem of glue joint is discussed.

并定性地讨论了胶螺接接头的耐久性问题。

2·He covered the miter with glue before making the joint.

他在进行斜面结合前给斜面涂了胶水。

3·In the glue processing, the design of the gluing joint is prerequisite and important.

胶接工艺中，胶接接头的设计是一重要的环节。

4·What's preferred is a direct joint between parts, bonded with glue.

人们更喜欢构件之间直接通过胶水来连接。

5·Tighten the clamps slowly to allow any excess glue to escape and leave the joint clamped until the glue sets.

要慢慢紧固夹钳，以便多余的胶水能被挤出来，在胶水固化前一直保持夹持状态。

6·Based on pressure and high low temperature cycling tests and theoretic analysis, the threaded joint parts filled with sealing glue compound show excellent seal ability, and can be applied to SRM.

通过压力、高低温循环等大量的试验和理论分析表明：采用填充密封胶的螺纹联接密封结构具有优异的密封性，适宜在固体火箭发动机环境中应用。

7·The rectangle floor adopts a split joint mode when being staggered, and the rectangle, square and triangle floors are mutually combined and slightly coated with glue at the connection thereof.

所述的长方形地板交错时采用搭接方式；所述的长方形、正方形和三角形地板相互组合后并于接口处略涂胶水。

8·Special glue is used on the surface of specimen , forming welding defect, which has little influence on microstructure and mechanical properties of joint.

待焊表面涂抹专用密封胶后，可形成结合线伸入缺陷，但对接头组织和力学性能影响不大。

9·A new seal structure suited to solid rocket motors (SRM) is introduced, and threaded joint structures and sealing glue compound are studied.

提出了一种适用于固体火箭发动机(SRM)的新型密封结构，并对应用于特定尺寸的螺纹联接结构方式、胶种选择进行了研究。

10·BW rubber expander glue bond substitutes for stepped joint or tongued and grooved joint in the horizontal joint site on the outside wall of basement.

在地下室外墙施工中 ，铺设BW温水膨胀橡胶止水条 ，取代了水平接缝处留阶梯缝或凸凹缝的作法 ；