全部

1·Stability welding process, welding spatter small.

焊接过程稳定，焊接飞溅小。

2·It has a low welding spatter and aesthetic formation of weld.

堆焊过程飞溅小，焊缝成型美观。

3·Equipped with damping device, reduces the welding spatter, and ensures welder's safety.

加装了阻尼装置，减少了焊接飞溅，保证了焊工的安全操作。

4·When welding spatter measures should be taken to prevent (such as lime brush method etc.).

焊接时应采取防飞溅措施(如刷白灰等方法)。

5·Paint coating, should take the rust coating parts, weld coating, welding spatter materials, oil, dust and other debris cleared.

油漆涂刷前，应将需涂装部位的铁锈、焊缝药皮、焊接飞溅物、油污、尘土等杂物清理干净。

6·The spatter rate was used to represent the welding stability by analyzing the relationship between stability and welding spatter.

论证了飞溅与焊接稳定性的关系，提出采用飞溅率表征焊接过程稳定性。

7·Effects of external characteristic of typical are welding power sources on the welding spatter was studied by the specific slope- controlled SCR are - welding rectifier.

利用特制的变结构晶闸管整流焊机，研究典型焊机外特性对焊接飞溅的影响；

8·Application of stainless steel after welding (not by steel) flat shovel thoroughly clean slag and spatter.

焊后应用不锈钢(不得采用碳钢)扁铲彻底清理熔渣和飞溅。

9·According to the characteristic of robotic arc welding inverter, two kinds of electronic reactances are designed to improve the spatter and weld appearance in the process of robotic CO_2 welding.

针对机器人用孤焊逆变器的特点，设计了两种形式的电子电抗器，用于改善机器人CO_2焊接过程的飞溅及焊缝成型问题。

10·The rage of Parameters for low the spatter loss with thd manual welding power sources was discussed.

探讨低飞溅率手工弧焊电源有关参数的合理调节范围。