全部

1·Internal Open Cell -replace.

内部公开赛细胞取代。

2·Based on object oriented and function components, the software architecture of open cell controller is built.

基于面向对象和功能组件，建立了开放式单元控制器的软件体系结构。

3·Open cell aluminum foams were prepared by traditional powder metallurgy process, with spherical carbamide particles as the space-holder.

以球形尿素颗粒为造孔剂，采用传统的粉末冶金工艺制备开孔泡沫铝并研究了其性能。

4·A open cell polyurethane rigid foam for vacuum panel core material was prepared. The open cell percent of the core material is about 95%.

制备了用于聚氨酯真空隔热板的开孔硬泡芯材，该泡沫芯材的开孔率达95%。

5·The results showed that the honeycomb laminates had an interlinking open cell structure without remarkable interface between silicone rubber and silicone rubber foam;

结果表明：蜂窝结构硅橡胶泡沫材料内部为大小不等但相互连通的开孔网络结构，泡沫与硅橡胶之间无明显界面；

6·According to the theory of classical mechanics, the problem of stress concentration of open cell of spherical cover end is always solved by approximate computing formula.

由经典力学理论，对于球形封头开孔应力集中问题，大都采用近似计算公式。

7·The factors affecting its thermal performance such as the cell size, open cell ratio and vacuum pressure have been discussed and the experimental results have been reported.

分析讨论了真空板芯材的泡孔尺寸、开孔率及真空度等因素对真空隔热板性能的影响并给出了试验结果。

8·Open cell aluminum foams were prepared by traditional powder metallurgy process, with spherical carbamide particles as the space-holder. The properties of open cell aluminum foams were studied.

以球形尿素颗粒为造孔剂，采用传统的粉末冶金工艺制备开孔泡沫铝并研究了其性能。

9·The result shows that the process conditions of polyester type open cell polyurethane foam are easy to control, and the mechanics performance of polyester type is better than that of polyether type.

实验结果表明：聚酯型网状聚氨酯泡沫塑料的制备工艺条件更容易控制，力学性能优于聚醚型；

10·In some cases the specific change triggers a signal - the folded or square position may activate some other enzyme, or open a channel in a cell.

在某些情况下特别的变化能触发一个信号——折叠的或方形的状态将激活一些其他的酶，或在细胞中打开一个通道。