全部

1·Furthermore, the application has to fully recover from the failure under constant load.

另外，应用程序必须在固定负载下从失败中全面恢复。

2·A constant load pattern is used to run the same user load during the run of a load test.

常数负载模式用来在负载测试执行期间执行相同的使用者负载。

3·On the Load Pattern page of the Load Test Wizard, select either Constant Load or Step Load.

在“负载测试向导”的“负载模式”页上选择“常量负载”或“分级负载”。

4·The Constant Load components remain unchanged throughout the entire pushover analysis procedure.

该常量荷载分量在推覆分析全过程中保持不变。

5·In the case of constant load, the energy release rate will increase with time until it reaches a higher limit value.

在常载荷的情况下，能量释放率将随时间而增长，直到它达到某一较高的极限值。

6·The internal forces composition mainly is the composition of horizontal earthquake forces, constant load and live load.

内力组合主要是水平地震作用、恒荷载作用、活荷载作用之间的组合。

7·Under constant load, the plastic deformation increased when the tendon under went a prolonged stretch or under warmer temperature.

在恒定载荷下，随持续拉伸时间延长或温度升高，肌腱的塑性变形明显增加。

8·Structural internal force is calculated by changing constant load of the main girder, the cable Angle, the length of unsupported deck.

通过改变主梁恒载重量、拉索倾角、无索区长度等结构参数，分析结构参数变化对结构受力的影响。

9·In the ambient vibration test, the dynamic characteristics of the bridge and the tension force of the cables under constant load were measured.

进行现场环境振动试验，测量了该桥的竖向、扭转动力特性，以及吊索恒载下的索力。

10·The calculation result on a 5 bus system shows that the new power flow algorithm based on constant load impedance can get more reasonable solution.

研究结果表明，电炉、电镀和电解等纯电阻性或近似电阻性负荷以恒定阻抗模型表示，潮流计算结果更加符合电力系统实际运行情况。