全部

1·Large door with front roller for easy can load in.

具有较大的门并附有向前伸出的滚桶，有利于桶的装载。

2·The pressure variation of front roller influences the drafting force slightly.

前罗拉压力改变对牵仲力影响很小；

3·The technological analyses concentrate onto the pressure on front roller and its stability;

工艺分析着重谈到前皮辊加压； 加压的稳定性；

4·By detecting the speed of front roller directly, the software changes the speed of tuber and lifter.

通过直接检测前罗拉输出速度，并由软件实现筒管卷绕速度和龙筋升降速度的改变；

5·A front roller and a rear roller can effectively reduce the labor intensity and increasing the operating quality.

前后辊轴可有效降低劳动强度，并有效提高作业质量。

6·By controlling the speed of front roller and back roller, the software controls the pulling times and twisting degree.

通过控制前罗拉与后罗拉的转速，由软件实现对粗纱牵伸倍数与捻度的控制。

7·The camber of the plate after cutting in disc type shear is reduced by adding hydraulic movable pusher in front of the shear and adjusting the side guide roller behind the shear.

通过在圆盘剪前增加液压活动推头和对剪后侧导辊的调整，减小了圆盘剪剪后钢板镰刀弯。

8·The Front Guards will help you riding off the rollers, in case you loose your balance badly. It will stop you riding off the roller, as well as slowing the wheel speed.

前轮防跌落保护器能够防止你在失去平衡或者减速的时候从滚筒上掉落。

9·This shall erect bell cleanup scrapper in front of belt-drive roller, so that this clean up crude coal adhered onto belt.

皮带驱动辊筒前安装有皮带清洁刮板，清除粘结于皮带上的原煤。

10·The front impact roller causes transverse plastic compression strain in the weld which is in the brittle temperature range, which counteracts the tensile strain which leads to hot cracking.

前轮对处于脆性温度区间的焊缝金属施加一个横向挤压塑性应变，减小甚至抵消致裂的拉伸应变，防止了焊接热裂纹的产生。