全部

1·Together, drive cache and algorithms work to improve the transfer of data in and out of the drive and to make parity calculations for RAID 5 implementations.

驱动器缓存和算法一起可以提高数据进出驱动器的速度，以及为RAID 5实现进行奇偶检验。

2·If you experience this situation, software RAID will allow the system to continue running, while you make arrangements to replace the failed drive with a new one.

如果您遇到这种情况，软件RAID将允许系统继续运行，同时您可安排用一个新的驱动器更换故障驱动器。

3·Make sure whatever number you have in mind matches your RAID-Z needs (e.g., at least five hard drives for this demonstration).

您需要牢记的是，无论使用多少设备，要确保这些设备能够满足您的RAID - Z需求(例如，对于此演示，至少需要5个硬盘驱动器)。

4·Make sure you can use your backup and rescue tools effectively and reliably on systems deployed on RAID devices.

确保你可以有效地使用备份和恢复工具，和在RAID设备上部署系统的可靠性。

5·Three hundred federal agents of the FBI and Internal Revenue Service were spanned across New Jersey and New York to make arrests and raid homes and offices.

FBI和美国国家税务局的三百名联邦调查员，部署在新泽西州和纽约州，突袭住处及办公室来实施拘捕。

6·If you're using RAID-0, make sure they're on separate disks and approximately the same size.

如果您使用的是RAID - 0，则应确保这些磁盘分区位于不同的磁盘上，并且其大小近似相同。

7·However, some of you may have read online that GRUB cannot install properly on RAID devices and that a manual intervention may be needed in order to make sure the system is bootable.

然而，有些人可能已经在线阅读了GRUB不能在RAID设备正常安装，并且需要手动干预确保系统可以启动。

8·Then, open it up and unplug one of the hard disks that make up your RAID-1 array.

然后，打开机箱，并断开组成RAID - 1阵列的一个硬盘。

9·The Linux kernel uses this information to auto-detect and start up RAID arrays at boot time, so you should make sure that every RAID volume you create is configured to do this.

Linux 内核使用这些信息在引导时自动检测并启动 RAID 阵列，因此您应确保对您创建的每个 RAID 卷进行了这种配置。

10·When you type make menuconfig or make xconfig, you'll find the Software RAID Settings under the Multi-device support (RAID and LVM) section.

当您输入“ make menuconfig ”或“ make xconfig ”后，您会发现软件RAID设置位于“ Multi - device support (RAID and LVM) ”部分。