全部

1·Adapt the adjusting stick to the variable capacitor aisle.

适应调整坚持可变电容器过道。

2·The variable capacitor was in poor condition when I received it.

可变电容器状况很差，当我收到它。

3·Variable capacitor soldering joints made with RG213 coaxial braid.

可变电容器的焊点与RG213同轴电缆编织的连接。

4·Represents a capacitor. Fixed or variable capacitor can be specified.

表示电容器。可指定固定或可变电容器。

5·To lower the operation frequency I use fixed capacitors in parallel with the variable capacitor.

为了降低操作频率，我用固定电容器，可变电容器并联。

6·They are for ground, antenna, detector tap and one wire to the stator of the variable capacitor.

它们是为地面，天线，探测器塔和一个钢丝向定子的可变电容器。

7·Leave 10 CMS of braid to solder to the air variable capacitor on the beginning and the end of the foam loop.

离开10的CMS编织焊接开始的空气可变电容器和泡沫循环结束。

8·A capacitor meter will be needed to read the capacitance from the temporally installed add on variable capacitor.

将需要一个电容计，读取时间安装的可变电容器的电容。

9·The type illustrated usually has trimmers built in (for making small adjustments - see below) as well as the main variable capacitor.

说明的类型通常有机内置（使小调整数-见下文）以及主要的可变电容器。

10·The tunability of VCO is normally provided by a variable capacitor. Achieving low phase noise requires a high-Q on-chip variable capacitor.

VCO的调谐能力通常由可变电容来实现，要获得低相位噪声，需要高Q值的片上可变电容。