全部

1·The rear axle carries the greatest weight.

后轴负荷最重的分量。

2·Then a rear axle gets stuck in the snow a little.

但不久后桥便较浅的陷进积雪中了。

3·On RWD cars, it is part of the rear axle assembly.

在后轮驱动车辆上，它通常也是装配在后轮驱动桥上。

4·The effective initial turning centre is behind the rear axle.

实际的初始转向中心在后轴之后。

5·Remove cardan shaft from rear axle differential and tie it up.

从后轴差速器上拆下万向节轴并将其绑紧。

6·The fracture occurred on the rear axle end of heavy automobile.

某重型汽车后桥轴头发生断裂。

7·You shouldn't end with a car with nonfunctional engine and twisted rear axle.

你不该这样结束了无功能的车发动机和扭曲后车轴。

8·Because of inertia, the front and rear axle load will shift when a vehicle braking.

由于惯性的影响，汽车在制动时，前后轴载荷会发生转移。

9·To further improve motoring sensation, BMW introduces a new kind of rear axle in 1990.

为了进一步提高其受欢迎程度，BMW于1990年推出了一种新的后轮轴。

10·The quenching distortion of rear axle spiral bevel gear used in FLAT tractor is studied in this paper.

研究了菲亚特拖拉机后桥大圆锥螺旋齿轮淬火变形规律，分析了原淬火压模存在的问题。

后桥

1·The track rod length is set so that its connection to the track arm falls on an imaginary line taken from the king pin to a point on the vehicle center line just in front of the rear axle.

转向横拉杆长度的设置要保证转向横拉杆与转向节臂的连接点位于主销到后桥前端汽车中心线上的点所形成的假想连线上。

2·The track rod length is set so that its connection to the track arm falls on an imaginary line taken from the king pin to a point on the vehicle center line just in front of the rear axle.

转向横拉杆长度的设置要保证转向横拉杆与梯形臂的连接点位于主销到后桥前端汽车中心线上的点所形成的假想连线上。

3·The assembly quality of automotive rear axle differential reducer is an important factor for the entire car performance.

汽车后桥差减速器的装配质量是影响整个汽车性能的一个重要因素。

4·The rear axle assembly equipment tires, can also be assembled steel wheel, formed three steel wheel, one machine.

该设备后桥可装配轮胎，也可以装配钢轮，形成三钢轮，一机两用。

5·The reason the propeller shaft shortens as the Angle increases is that the rear axle and differential move in a shorter ARC than the propeller shaft.

当角度增加时，传动轴变短的原因是后桥和差速器运动的弧度小于传动轴运动的弧度。

后轴

1·Remove cardan shaft from rear axle differential and tie it up.

从后轴差速器上拆下万向节轴并将其绑紧。

2·A software function that allows you to read the front and rear axle loads on trucks equipped with EBS and air suspension.

使用该软件功能，您可以在安装了EBS和空气悬挂的卡车上读取前、后轴的载荷。

3·Distributes the moment released by the gear via the cardan shafts to the frontaxle final drive or rear axle differential.

通过万向节轴将齿轮传递的力矩分配给前轴主减速器或后轴差速器。

4·Because of inertia, the front and rear axle load will shift when a vehicle braking.

由于惯性的影响，汽车在制动时，前后轴载荷会发生转移。

5·However, if either front wheel spins, all the traction is transferred to the rear axle.

然而，如果前轮旋转，所有的牵引力转移到后轴。