全部

1·TC1 is mounted directly on the pump inlet tee replacing the convectron gauge shown on the diagram.

TC1直接安装在泵进口三通上，取代图中所示的对流管压力表。

2·Each fluid enters through its own pump inlet and outlet.

各种流体进入其自己的泵入口和出口。

3·Two different views show the completed oil pump inlet elbow.

两种不同的意见显示完成油泵入口肘。

4·Import filter of pump inlet ensures pump for a long working life;

液压油泵进口配置吸油滤油器， 确保液压油泵的使用寿命；

5·The pump inlet filter program kept clean so as not to exhaust slowed down.

泵进气口的过滤纲保持清洁，以免抽气速度下降。

6·Softened water must be used. The filter units must be added at water pump inlet.

必须使用软化水。水泵吸水口必须加过滤装置。

7·Circulating water pump inlet pipe and outlet pipe should also install pressure gauge.

循环水泵的进水管和出水管上也应装压力表。

8·Pump inlet pipe diameter changes when level, should choose eccentric different-diameter pipe.

泵的水平入口管变径时，应选用偏心异径管。

9·When the inlet diameter is greater than pump inlet should be installed eccentric adjustable tube.

当进水管直径大于水泵进水口时，应安装偏心变径管。

10·Mating portions on the frame and tank (140) guide engagement of a tank outlet with a pump inlet tube.

框架和贮罐(140)上的配合部分导引贮罐出口与泵入口管接合。