全部

1·The rigid cover plate is provided with two grout holes.

刚性盖板设置两个灌浆孔。

2·Reattach cover plate to make an air and water tight seal.

重新固定盖板，并紧密密封防止空气和水通过。

3·The handle of cover plate is adopted as retractable handle.

盖板把手改为可折叠式。

4·The injection mould for a duplicator cover plate is designed.

设计了复印机盖板的注塑模具。

5·Remove all nuts and bolts from cover plate and take off plate.

从盖板上拆卸所有螺母和螺栓，然后将盖板拿开。

6·In addition, one-inch horizontal cover plate can prevent accidents.

此外，一英寸的板块横罩可有效防止发生意外。

7·Cooling condition of the market, the developers choose to cover plate.

冷却条件的市场，开发商选择盖板。

8·Or texture of soft flexible rubber airtight floor drain in the cover plate on.

或用质地软有弹性不透气的橡胶板遮盖在地漏上。

9·Caution: Do not loosen nuts on cover plate - This will result in loss of pre-charge.

警告：不要松开盖板上的螺母-这样做可能会导致预充气压力的损失。

10·Original create hit-proof decoration cover plate, make it perfect, luxury and elegant.

独创扇防撞装饰盖板，使外观趋于完美，既豪华又典雅。

盖板

1·Caution: Do not loosen nuts on cover plate - This will result in loss of pre-charge.

警告：不要松开盖板上的螺母-这样做可能会导致预充气压力的损失。

2·Cooling condition of the market, the developers choose to cover plate.

冷却条件的市场，开发商选择盖板。

3·If you open the cover plate of your cell phone you'll see a rectangular LCD on its backside.

把手机的盖板打开来，背面就是一整片长方形的液晶萤幕。

4·Otherwise, the bracket should be placed in the bottom of the main horizontal cover plate near the main beam two points to high.

否则应把支架垫在主梁的下水平盖板靠近主梁两点变高处。

5·Analyzed the forming process of the cover plate, introduced the layout design, and expound design and manufacture process of die structure and its main components.

分析了盖板零件的冲压成形工艺，介绍了零件排样设计方案，阐述了模具结构及其主要零件的设计和制造工艺。