全部

1·Axial clearance is bigger, bearing damage easily.

轴向游隙较大时，轴承容易损坏。

2·According to the movement direction, it falls into radial clearance and axial clearance.

根据移动方向，可分为径向游隙和轴向游隙。

3·The head coefficient, power coefficient, and efficiency decreased with increasing axial clearance.

随轴向间隙扩大，超小型泵的扬程系数、功率系数和效率都逐渐降低。

4·This paper presents a new method for detecting the axial clearance of a bearing by a single chip processor 8098.

本文提出使用8098单片机实现轴承轴向间隙检测的新方法。

5·The axial clearance is the total amount that one ring can be displaced relative to the other in an axial direction.

轴向间隙的总金额，一个环可以流离失所相对于其他的轴线方向。

6·The presented problems and resulted harm about air seal axial clearance in a centrifugal compressor are pointed out.

指出了离心空压机气封轴向间隙存在的问题及造成的危害。

7·With tight fits (see pages 105 and 114) the axial clearance is reduced or the preload of the bearing pair increased.

过盈配合情况下（见第105和114页），轴向间隙减小，或者铰副预加负荷增加。

8·The bearings are generally installed with a small axial clearance in order to compensate for length variations of shaft and housing.

轴承一般设一个小轴向间隙，以弥补轴和轴承座的长度变化。

9·On the other hand, we should proceed strict detecting including inner and outer diameter, radial and axial clearance to ensure quality.

另一方面是轴承在生产时进行严格的检测，包括内外径、游隙等，以保证质量。

10·Disk rotation balance week, will go to a certain point of view, the local emergence of the greatest axial clearance or minimum clearance space.

平衡盘转动一周，会在转到某一角度时，局部出现轴向间隙的最大间隙或最小间隙。