全部

1·Using vernier calipers, measure the slip ring diameter.

用卡尺，测量滑环的直径。

2·The structure of a large slip ring for continuous signal is described.

介绍一种大型连续式信号汇流环的结构。

3·2 check the excitation system, inspect the running state of the slip ring and the commutator.

检查励磁系统，检查滑环和整流子的运行状态。

4·Equipped with a closed transmission slip ring, cable is not wrapped, good electrical conductivity.

配置封闭式输电滑环，电缆线不缠绕，导电良好。

5·Remove brushes and short the ring together with a copper link in case of a slip ring motor (wound rotor).

若是滑环式电动机(绕线转子)，去除电刷，和铜环连在一起使滑环短路。

6·Route the wiring and make the neccessary connections. Do not allow the wiring to restrict free rotation of the slip ring.

把导线排好并做必要的连接，防止导线妨碍电气滑环的自由旋转。

7·The slip ring should be used in dry, low dust environment. If working environment is bad, more protection measures should.

滑环系精密电气元件，应使其在一个干燥，少尘的环境下工作。如果环境条件恶劣，应增加防护措施。

8·In the past, signal between stationary platform and rotary platform transmitted by electronic slip ring in order to realize remote control.

早期，旋转平台间的信号传输与控制采用电滑动环旋转传输电信号来实现。

9·The explosion-proof cable drum adopts a novel slip ring group, guarantees enough contact area and compression strength, and better transfers current.

采用新型的滑环组，保证足够的接触面积和压紧 强度，更好的传递电流。

10·Via slip ring disposal and modifying program of rotor one point ground protection, rotor one point ground protection operation again is effectively avoided.

通过对发电机滑环的处理及对转子一点接地保护程序的修改，有效地避免了发电机转子一点接地保护动作的再次发生。

滑环

1·Using resistance strain gage, dynamic pressure sensor, slip ring and tape recorder, the blade vibration strain and exit pressure signals of rotor blades are recorded and then processed.

利用电阻应变片、动态压力传感器、滑环式引电器和磁带记录仪等，录取叶片振动应变和动叶出口压力信号，然后回放磁带，做信号处理。

2·Via slip ring disposal and modifying program of rotor one point ground protection, rotor one point ground protection operation again is effectively avoided.

通过对发电机滑环的处理及对转子一点接地保护程序的修改，有效地避免了发电机转子一点接地保护动作的再次发生。

3·Equipped with a closed transmission slip ring, cable is not wrapped, good electrical conductivity.

配置封闭式输电滑环，电缆线不缠绕，导电良好。

4·The liquid resistance value can be altered by adding in standby raw material and is applicable for slip ring electrical motor of light load, medium load and heavy load starting up.

液体阻值通过添加备用原料来改变。适用于轻载，中载，重载起动的滑环电机。

5·2 check the excitation system, inspect the running state of the slip ring and the commutator.

检查励磁系统，检查滑环和整流子的运行状态。