全部

1·The engagement section having a T-shaped cross-section may have an L-shaped member, a washer, an intermediate member, a threaded bolt and a nut.

订婚后的第一个T形截面可能有一个L形的成员，洗衣机，中间成员，螺纹螺栓和螺母。

2·He says a little machining needs to be done on the cathode tube, making a threaded bolt hub that is welded to the tube via an inert gas shield welder, or tig.

他说，一点点加工需要做的阴极管，螺纹螺栓作出枢纽这是焊接管通过一个惰性气体保护焊机，氩弧焊或。

3·The value of tightening torque is relative not only to the nominal diameter and quality class of the bolt, but also to the security of the threaded fastener.

指出螺栓联接的扭紧力矩值不仅与螺栓的公称直径及性能等级有关，还与能否保证联接可靠工作有关。

4·Girth flange bolting shall be of stud bolt type, threaded full length, and at least M16 for flange of 600 mm and smaller inside diameter and at least M20 for over 600 mm inside diameter flange.

翼缘法兰螺栓应为双头螺栓，螺纹为全长型，内径600 mm或以下的法兰的螺栓至少为m 16，内径600 mm以上的法兰的螺栓至少为m 20。

5·Threaded rock bolts shall be provided with rolled threads of min. 150 mm length of the same corrosion protection or better than the bolt itself.

螺纹岩石锚杆应具有滚压螺纹，最小防腐蚀保护长度150mm，或者比锚杆本身要好；

6·Tapping is the process of cutting a thread inside a hole so that a cap screw or bolt may be threaded into it.

攻丝是在一个孔中车出螺纹，以便装上有帽螺钉或螺栓。

7·The screw of bolt revolted into threaded hole directly and the screw thread of them are combined tightly, so the two boards can be connected together firmly.

所述螺钉的螺杆直接旋入所述固定件的螺孔内，二者的螺纹紧密结合，从而可将两板体牢固连接于一起。

8·If neither part is threaded a bolt must be used: this consists of a screw with a hexagonal head.

如果两者皆不的部份被穿线于门闩一定被用：这用一个六角形的头有螺丝钉。

9·One end of the jack bolt is positioned in the threaded hole at one side of the flat hole sleeve.

顶丝的一端置入扁平孔套一侧的螺纹孔内。

10·The high-strength right-screwing threaded steel bolt is formed by full thread reinforcing bars and cast steel nuts.

一种高强度右旋螺纹钢锚杆，是由全螺纹钢筋和铸钢螺母构成。