全部

1·For the oil level gauge, observation hole and the best use of natural materials, glass or polyamide materials.

用于油位计、观察孔等的材料，好使用天然玻璃或聚酰胺材料。

2·This paper Outlines a special gauge suitable for measuring the hole positions or distance between two holes in the cylinder blocks.

介绍了一种适用于测量气缸体上各孔位置及任意两孔间距离的专用测量工具。

3·The Toolpusher or Senior Driller shall verify all stabilisers, reamers and bits will be gauged with appropriate ring gauge to ensure proper size before running in the hole.

入井前，带班队长或司钻要用合适的测量规核实扶正器、扩眼器、钻头，确保尺寸合适。

4·This paper studies concept, calculation and gauge design concerned with coaxality of main spindle hole and camshaft hole and points out some common errors.

对柴油机主轴孔、凸轮轴孔同轴度的有关概念、计算方法、量规设计理论进行探讨，指出通常一些做法的错误。

5·This is a gauge to inspect whether the diameter of hole is larger than the specified MML or not , and this shall pass through the overall length of hole without any difficulty.

本量规用于检查孔的直径是否大于被规定的最大实体尺寸，要能够轻易的通过孔的全长。

6·For high accuracy of electronic gauge, it can reflect minor change of pressure at down hole clearly and obtain information furthest.

电子压力计因其精度高，可以更清楚地反映井下的微小压力变化，最大限度地获取地层信息量。

7·There is Burst disk pressure in the gauge, blow out hole in the back to relief the presure inside caused by failure of elastic element.

背部，设有泄压后盖及泄压孔，以释放因过载弹性元件破裂而产生的内部压力，增强了人员及设施的安全性。

8·Should the car need a higher octane rating, there will be an indication in the owner's manual and perhaps under the fuel gauge and by the fuel fill hole.

应该车需要更高的辛烷值，将会有一个想法在老板的手册，也许在燃料表填孔和燃料。

9·Usually the hole-based system is used, as the results in a reduction in the variety of drill, reamer, broach and gauge tooling required.

通常使用的是基孔 制，因为这会减少所需要的钻头、铰刀、拉刀和计量工具的种类。

10·Residual stress distribution of FSW has high gradient, which makes the conventional strain gauge hole drilling method unsuitable.

应变片钻孔法是工程中应用最广的残余应力测量方法之一。