全部

1·Required cure time depends on temperature, pipe diameter, and pressure application.

所需要的固化时间与温度、管道直径和应用压力有关。

2·The coating manufacturer shall be consulted to ascertain the proper cure time and methods.

需要咨询喷涂厂家确定适当的固化时间和方法。

3·The higher the temperature is, the longer cure time is, the larger volumetric expansion will be.

并且苯并恶嗪的固化温度越高，时间越长，体积膨胀效应就越大。

4·Following the cure time for the repair product, as described above, the repair shall be re-tested.

在上述修补产品固化后，应再次检查修补部位。

5·Now, if you discount your water (use less water than your recipe calls for) you can reduce your cure time.

老手是可以从配方中去减少水量以达到缩短晾皂的时间。

6·The influences of cure temperature, cure time and ambient humidity on the properties of the dam blank were discussed.

探讨了养护温度、养护时间和环境湿度对坯体性能的影响。

7·Besides the scorch time and optimum cure time of BIIR were shortened considerably while its curing rate increased obviously.

与丁基橡胶相比，BIIR焦烧时间和正硫化时间明显缩短，硫化速度大大提高。

8·The results show that with the increase of the amount of silica, the scorching time and optimum cure time of CR/TPI compounds are shortened.

结果表明，白炭黑能加速CR/TPI并用胶的焦烧性能，同时降低了胶料的硫化速度。

9·With the increasing of cure temperature, the scorch time and optimum cure time decreased, but the crosslink density had a tread of decreasing.

硫化温度的提高会缩短焦烧时间和正硫化时间，但有使交联密度下降的趋势。

10·With the same recipe, shorter cure time, comparative smaller degree of two laser beams and thinner PDLC film give rise to higher diffraction efficiency.

较小的膜层厚度、较小的光束夹角和较短的曝光聚合固化时间有利于衍射效率的提高。