全部

1·Repeat the leak test in the water bath.

在水槽中重复泄漏测试。

2·Fill system with Dl water and perform leak test with circulation pump.

向系统中填充去离子水并用循环泵测漏。

3·When welding is required, all welds are subject to leak test to ensure the washer is water tight.

当需要焊接时，所有的焊接需进行泄漏测试，以确保清洗机没有任何漏水处。

4·Say goodbye to expensive, poor performing, unreliable and difficult to maintain leak test systems.

向昂贵的，低性能的，不可靠的，难维持泄露检测的系统告别吧。

5·I pneumatic leak test at a pressure of not less than 6 bar after assembly of all tank valves and fittings.

气阀及配件装配后不少于6巴压力的气压测漏报告。

6·So please do your leak test and connect your sample line to sample inlet only after all leak tests are done.

因此，请检漏并在检漏工作全部结束后再连接样品管与样品进口。

7·Where possible, the closed position should be determined by leak test using water or air, under low pressure.

如果可能的话，可以用水或空气，在低压状态下，对关闭状态进行测试，看看有没有泄漏。

8·These low operating cost systems can leak test, performance test, or run test your systems and your products.

运转成本低，用于进行泄露测试、性能测试或检测系统和产品。

9·As a seal test, sensitivity of helium leak test is higher than other test methods as gas seal and NH_3 leak test.

氦泄漏试验作为一种致密性试验，它的检漏灵敏度远远超过了气密性试验和氨渗漏等试验方法。

10·The paper describes in detail the hardware network of the vacuum leak test system and the data acquisition software.

文章详细介绍了真空检漏设备数据采集系统硬件网络的构建以及软件的开发。