全部

1·Thewhole set of equipment can replace traditional steel slab rust-re-moved technique.

整套设备一人操作，可替代传统的钢板酸洗除锈工艺。

2·This paper introduces the importance of developing the diagnostic system in steel slab production.

本文介绍了开发钢铁生产主线板坯缺陷的诊 断系 统的必要性；

3·Three-dimensional measurement of the size of a moving hot steel slab using an area-array CCD camera is proposed.

首次提出用一台面阵CCD摄像机测量运动高温钢坯的三维尺寸。

4·The optical microscope and SEM were applied to analyze the formation mechanism of transverse corner cracks of Nb microalloyed steel slab.

采用金相显微镜和扫描电镜分析了含铌微合金化钢铸坯角部横裂纹的形成原因。

5·The improvement of slab equiaxed crystal ratio by electric pulse on liquid steel in continuous casting mould at Pan steel slab castor No.

从结晶器施加电脉冲输入能量、钢液过热度、电极间距三方面，探讨电脉冲处理提高铸坯等轴晶率的效果。

6·The establishing method for the on -line mathematical model of the steel slab heating and several major control strategies are described emphatically.

重点叙述了钢坯加热在线数学模型的建立方法和几个主要控制策略。

7·In order to reduce the inclusion quantity in the stainless steel slab, water-modeling experiment of stainless steel slab continuous casting tundish is launched.

为减少不锈钢连铸坯中夹杂物的数量，开展了不锈钢板坯连铸中包水模实验。

8·The new technologies of heating steel slab billet using natural gas as fuel and regenerative combustion way are mainly described, as well as obvious energy saving results are gained.

着重叙述了用天然气作燃料，采用蓄热式燃烧方式加热钢板坯的新技术，以及加热炉取得了显著节能效果。

9·The results showed that the bubbly defects were caused by banded inclusion lied in steel slab from mould powder and plastic deformation were not consistent from center to the surface during rolling.

鼓泡主要是在钢坯皮下由保护渣形成了层状夹杂，导致冷轧原料板出现分层，从而在轧制过程中心部、表面的塑性变形不一致而形成。

10·First, by placing the concrete slab above the neutral axis of the steel, our COS Decks maximize the strengths of both steel and concrete.

首先，通过把混凝土板置于钢筋中轴之上，我们的这款桥面最大限度地加大了钢铁和混凝土的强度。